S5 Chemistry Practice Paper | mole and concentration, acid-base titration, electrolysis and charge, reaction rate, neutralisation enthalpy, molar volume
- 2026-11-17
S5 Chemistry practice paper with answers: molar mass, titration, electrolysis and charge, reaction rate and temperature, neutralisation enthalpy and molar gas volume.
Question 1 Molar mass and concentration
5.30 g of anhydrous sodium carbonate (Na2CO3) is dissolved in distilled water and made up to 250 cm3 in a volumetric flask. (Relative atomic masses: Na = 23.0, C = 12.0, O = 16.0)
| # | Question | Answer and marking notes |
|---|---|---|
| 1 | (a) Find the molar mass of Na2CO3 and the number of moles in 5.30 g. | Answer: molar mass = 106 g/mol, moles = 5.30 / 106 = 0.050 mol. |
| 2 | (b) Find the concentration of the solution in mol/dm3. | Answer: 0.050 / 0.250 = 0.200 mol/dm3. |
| 3 | (c) 25.0 cm3 of the solution is taken. Find the number of moles of sodium ions. | Answer: Na2CO3 = 0.200 x 0.0250 = 0.0050 mol, so Na+ = 0.0100 mol. |
| 4 | (d) To prepare 500 cm3 of 0.100 mol/dm3 solution, what mass of Na2CO3 is needed? State one key step when making up to the mark. | Answer: 0.050 mol gives 5.30 g; make up to the 500 cm3 mark and mix, rather than adding 500 cm3 of water. |
Question 2 Titration with sodium carbonate
25.0 cm3 of 0.100 mol/dm3 sodium carbonate standard solution is titrated with hydrochloric acid of unknown concentration; 24.0 cm3 of the acid is needed for complete neutralisation. Na2CO3 + 2HCl gives 2NaCl + H2O + CO2.
| # | Question | Answer and marking notes |
|---|---|---|
| 5 | (a) Find the moles of sodium carbonate and the concentration of the acid. | Answer: 0.0025 mol of Na2CO3 gives 0.0050 mol of HCl, so c = 0.21 mol/dm3. |
| 6 | (b) If 0.150 mol/dm3 acid is used instead, what volume is needed for the same aliquot? | Answer: 0.0050 mol / 0.150 = 33.3 cm3. |
| 7 | (c) If the acid is added only to the first equivalence point (forming NaHCO3), what volume is needed? | Answer: only 0.0025 mol, giving 12.0 cm3. |
| 8 | (d) If the pipette is rinsed with distilled water but not with the carbonate solution, how is the calculated acid concentration affected? | Answer: residual water dilutes the aliquot, less carbonate is present, the titre is smaller, so the calculated acid concentration is too low. |
Question 3 Electrolysis and quantity of charge
A current of 2.00 A is passed through copper(II) sulphate solution for 30.0 minutes. (Faraday constant 96500 C/mol, Cu = 63.5, Ag = 108)
| # | Question | Answer and marking notes |
|---|---|---|
| 9 | (a) Find the quantity of charge passed and the moles of electrons. | Answer: Q = 2.00 x 1800 = 3600 C, giving 0.0373 mol of electrons. |
| 10 | (b) The cathode reaction is Cu2+ + 2e- gives Cu. Find the mass of copper deposited. | Answer: 0.0187 mol of Cu, that is 1.18 g. |
| 11 | (c) With the same charge, what mass of silver is deposited from silver nitrate solution? | Answer: 0.0373 mol, that is 4.03 g of silver. |
| 12 | (d) At 3.00 A, how long is needed to deposit 3.175 g of copper? | Answer: 0.1000 mol of electrons need 9650 C, so about 53.6 minutes. |
Question 4 Rate of reaction and temperature
Magnesium reacts with dilute hydrochloric acid and the hydrogen is collected. 48.0 cm3 is collected in the first 40 s; the reaction finishes in 120 s with 168 cm3 in total.
| # | Question | Answer and marking notes |
|---|---|---|
| 13 | (a) Find the average rate over the first 40 s in cm3/s. | Answer: 48.0 / 40 = 1.20 cm3/s. |
| 14 | (b) Find the average rate for the whole reaction and explain the higher initial rate. | Answer: 168 / 120 = 1.40 cm3/s; the acid concentration, and hence the collision frequency, is highest at the start. |
| 15 | (c) Replacing the magnesium ribbon with the same mass of magnesium powder, how does the rate change? Explain. | Answer: much faster, because the larger surface area exposes more particles to the acid, raising the collision frequency; the total volume of gas is unchanged. |
| 16 | (d) The rate roughly doubles for every 10 C rise. From 20 C to 40 C, by what factor does the rate increase and what is the new completion time? | Answer: 4 times faster, so about 30 s. |
Question 5 Enthalpy of neutralisation
50.0 cm3 of 1.00 mol/dm3 hydrochloric acid is mixed with 50.0 cm3 of 1.00 mol/dm3 sodium hydroxide in a polystyrene cup; the temperature rises from 25.0 C to 31.8 C. Assume a density of 1.00 g/cm3 and a specific heat capacity of 4.2 J/(g C).
| # | Question | Answer and marking notes |
|---|---|---|
| 17 | (a) Find the heat released in kJ. | Answer: 100 x 4.2 x 6.8 = 2856 J, that is 2.856 kJ. |
| 18 | (b) Find the molar enthalpy change of neutralisation. | Answer: 0.0500 mol of water formed, so the enthalpy change is -57.1 kJ/mol. |
| 19 | (c) If 0.50 mol/dm3 acid and alkali are used instead, what temperature rise is expected? | Answer: about 3.4 C, since half as many moles react. |
| 20 | (d) Replacing the acid with ethanoic acid of the same concentration and volume, would the magnitude of the enthalpy change be larger or smaller? Explain. | Answer: smaller, because a weak acid is only partly ionised and ionising the rest absorbs energy, so less net heat is released. |
Question 6 Molar volume of gases
At room temperature and pressure the molar volume of a gas is 24.0 dm3/mol. (C = 12.0, O = 16.0, Mg = 24.0)
| # | Question | Answer and marking notes |
|---|---|---|
| 21 | (a) Find the moles and mass of 4.80 dm3 of carbon dioxide at room conditions. | Answer: 0.200 mol, that is 8.80 g. |
| 22 | (b) 6.00 g of magnesium reacts completely with excess dilute acid. Find the volume of hydrogen at room conditions. | Answer: 0.250 mol of H2, that is 6.00 dm3. |
| 23 | (c) 2.00 mol of nitrogen is mixed with 3.00 mol of oxygen. Find the total volume at room conditions and the mole fraction of nitrogen. | Answer: 5.00 mol in total gives 120 dm3, with a nitrogen mole fraction of 0.400. |
| 24 | (d) What volume would the same 0.200 mol of gas occupy at s.t.p., where the molar volume is 22.4 dm3/mol? | Answer: 4.48 dm3, smaller than 4.80 dm3 because the temperature is lower. |
Find a tutor — freeTutor Registration →
A TutorZone practice paper; original questions and passages, not publisher material.



