IGCSE Chemistry — Bonding and Structure: Lesson Prep Guide for Tutors
- 2026-11-16
Students forget the square brackets on ions and then answer that solid sodium chloride conducts because it contains ions. This lesson fixes the chain from structure to particle to property, using the melting points of magnesium oxide and sodium chloride.
01 Prerequisites (3-minute check)
If any of these fails, fix it before the lesson starts.
| Skill | Quick check | Pass mark |
|---|---|---|
| Atomic structure | writes 2,8,8 configurations and locates elements in the periodic table | Atomic structure chapter |
| Ion charges | knows metals lose electrons and non-metals gain them | Five-minute check at the start |
| Formulae | writes a formula from a compound name | Junior science |
02 Lesson flow (45 minutes)
| Time | Stage | Tutor does | Student does |
|---|---|---|---|
| 0-6 min | Diagnostic | Ask whether solid sodium chloride conducts, collect answers without correcting them | Students commit to an answer in writing |
| 6-16 min | Ionic bonding | Start from 2,8,1 and 2,8,7 and move one electron across | Draw Na+ and Cl- with brackets and charges |
| 16-28 min | Covalent bonding | Count valence electrons and pair them up | Produce dot-and-cross diagrams for CH4 and CO2 |
| 28-38 min | Structure and properties | Build a four-row table of structure, particles, melting point, conductivity | Explain why MgO melts above NaCl |
| 38-45 min | Exit check | Three questions, each wrong answer mapped to a scene | All three correct |
03 Teaching script (read it out)
Scene 1: Scene one: ionic bonding moves whole electrons, it does not share them
Ask one student to restate: an ionic bond is the electrostatic attraction between oppositely charged ions after whole-electron transfer.
Scene 2: Scene two: covalent bonding counts valence electrons, not atoms
Ask one student to restate: write the valence electron total first, then hand out pairs until every atom has eight.
Scene 3: Scene three: properties follow from structure in three steps
Ask one student to restate: conduction needs charged particles that are free to move, and a solid ionic lattice has none.
04 Question types and worked steps
| Type | Example | Steps | Answer |
|---|---|---|---|
| Ionic dot-and-cross diagram | Write both configurations, move the electrons, then add brackets and charges | ||
| Covalent dot-and-cross diagram | Total the valence electrons, pair them, then check every atom has eight | ||
| Formula from ion charges | Write both charges and cross them over, so Mg2+ with Cl- gives MgCl2 | ||
| Structure to property explanation | Name the particle, describe the arrangement, then state the property in three sentences |
05 Independent practice (3 questions)
| Question | Answer | What to watch |
|---|---|---|
| How many electrons does Mg2+ have? | Ten, since magnesium has twelve and loses two | Do they subtract rather than add? |
| What is the configuration of Cl-? | 2,8,8, giving eighteen electrons | Have they counted chlorine as seventeen? |
| What is the formula of the compound of magnesium and chlorine? | MgCl2 | Do they use charge balance rather than memory? |
| What is the valence electron total in CH4? | Eight, from four plus four times one | Did they total before drawing? |
| Why does solid sodium chloride not conduct while the molten salt does? | Solid ions are fixed in the lattice; molten ions are free to move | Do they say the words free to move? |
06 Common mistakes and what to say
| Mistake | Student writes | Say this |
|---|---|---|
| No brackets or charges on the ions | The diagram shows two atoms sharing electrons, becoming covalent | An ion has moved its electron away, so it needs brackets and a charge. |
| Bonds drawn per atom without counting valence electrons | Carbon dioxide comes out with single bonds and oxygen with six electrons | Total the valence electrons first, sixteen here, so eight pairs in all. |
| Assuming a solid ionic compound conducts | The answer says it conducts because it contains ions | The ions are locked in the lattice, so nothing can move; melt it and try again. |
| Using relative mass to explain melting point | The answer says MgO melts higher because it is heavier | Melting point follows charge and structure, not mass; plus two against plus one is the reason. |
07 Homework (paper, section and question numbers)
- Independent practice set above, with configurations shown for each item — Questions 1 to 5
- IGCSE Chemistry guide index, for comparison with stoichiometry and rates — Questions 1 to 8
08 Exit check (last 5 minutes)
| Question | Answer | Decision |
|---|---|---|
| What is the electron configuration of Na+? | 2,8 | Wrong: redo scene one |
| How many bonds are in carbon dioxide, and of what type? | Two double bonds, both covalent | Wrong: redo scene two |
| Why does MgO melt above NaCl? | Its ions carry plus two and minus two, so the attraction is stronger | Wrong: redo scene three |
09 Tutor FAQ
Why do ionic diagrams need square brackets?
The brackets mark a whole charged particle, with the charge written at the top right. This is the standard convention in IGCSE mark schemes, and omitting brackets or charges usually loses the mark even when the electron count is right.
Diamond and graphite are both carbon, so why does only one conduct?
Each carbon in diamond uses four covalent bonds in a three-dimensional network, so every electron is held in a bond; in graphite each carbon uses three bonds and the fourth electron is delocalised between layers, so it can move.
Must students memorise melting points?
No, but three values make comparison easy: sodium chloride near 801 degrees Celsius, magnesium oxide near 2852 degrees Celsius, and carbon dioxide subliming at minus 78 degrees Celsius. Examiners usually supply data and ask for the explanation.
Find a tutor — freeTutor Registration →
A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.



