/en-tutor-prep-igcse-chemistry-energetics-reaction-rates/
/en-tutor-prep-igcse-chemistry-energetics-reaction-rates/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

IGCSE Chemistry: Energetics and Reaction Rates Lesson-Prep Guide (for tutors) | Enthalpy calculations, calorimetry and collision theory

IGCSE Chemistry: Energetics and Reaction Rates Lesson-Prep Guide (for tutors) | Enthalpy calculations, calorimetry and collision theory

  • 2026-11-16

Students see a temperature rise and write that the reaction absorbed heat, then claim a catalyst releases more energy, and flip the sign on every enthalpy change. The marks cluster in three places: the direction of heat flow, the sign and unit of enthalpy change, and naming only one of the two collision conditions. This lesson fixes both sides of the sign with a 4,200 joule calorimetry route and a bond energy calculation of minus 184.

Objectives — By the end of the lesson students can: (1) decide exothermic or endothermic from the energy gap between reactants and products, stating that exothermic means a temperature rise with a negative enthalpy change, and illustrate the reverse with ammonium nitrate dropping the temperature by 8 degrees; (2) compute the enthalpy change of H2 plus Cl2 giving 2HCl from bond energies, 436 plus 242 equals 678 broken and 2 times 431 equals 862 formed, giving minus 184 kilojoules per mole; (3) use q equals mc delta T to get 4,200 joules for 100 grams of water rising 10 degrees, convert 0.005 moles of fuel to 840 kilojoules per mole, and use collision theory to explain how temperature, concentration, surface area and a catalyst change the rate.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Moles How many moles are there in 0.24 grams of magnesium? 0.01 moles, using 24 as the relative atomic mass
Energy and temperature When the temperature rises, does energy enter or leave the solution? Energy enters the solution, so the reaction is exothermic
Bonding Does breaking a bond absorb or release energy? It absorbs energy, and forming a bond releases it

02 Lesson flow (60 minutes)

Time Stage Tutor does Student does
0-6 min Opening question Dissolve ammonium nitrate and ask why the thermometer falls 8 degrees Write an answer and reason to compare later
6-20 min Act 1: exothermic and endothermic Use energy diagrams to fix the sign of the enthalpy change Draw both diagrams with arrows
20-36 min Act 2: bond energies and calorimetry Compute 678 and 862 for minus 184, then 4,200 joules and 840 per mole Work one calculation alone and check the sign
36-48 min Act 3: collision theory and rate Use magnesium and acid for four factors and a rate of 2.5 cubic centimetres per second Explain why powder beats ribbon
48-54 min Practice and correction Set four questions and hunt for catalysts changing the enthalpy change Work independently and correct
54-60 min Exit check Ask three core questions Answer orally, log errors as homework

03 Teaching script (read it out)

Scene 1: Heat flow follows the energy gap, not the direction of the thermometer reading alone

Draw an energy diagram with energy on the vertical axis, reactants on the left and products on the right. If the products sit lower, the surplus leaves as heat, the temperature rises and the enthalpy change is negative, which is exothermic; if the products sit higher, energy is taken in from the surroundings, the temperature falls and the change is positive. Fix the direction with two examples: burning methane, CH4 plus 2O2 giving CO2 plus 2H2O, has an enthalpy change of minus 890 kilojoules per mole, which is 890 over 16, so 55.6 kilojoules per gram; dissolving 25 grams of ammonium nitrate drops the water by 8 degrees, absorbing 25 times 4.2 times 8, which is 840 joules, so that process is endothermic. Students must always write three things that agree: the diagram heights, the sign of the change and the thermometer reading. Add the standard trap: a negative sign means the system releases energy, not that the number is small, so write the size as a positive number with a minus in front and never write a double negative.
Students do: draw both diagrams and label the sign of each enthalpy change.

If a student says a temperature drop means the reaction released heat, ask where the heat went and push for energy moving from the water into the reaction.

Scene 2: Bond energy questions have one formula: broken minus formed, and the sign then looks after itself

Split H2 plus Cl2 giving 2HCl into two steps. First break the bonds in the reactants: H to H is 436 and Cl to Cl is 242, so 678 kilojoules are absorbed. Then form the product bonds: two H to Cl at 431 each is 862 kilojoules released. The enthalpy change is absorbed minus released, 678 minus 862, which is minus 184 kilojoules per mole, and the negative sign shows a net release. Students must write the two subtotals before subtracting, because reversing the order is the commonest lost mark. Then take the combustion route: burning 0.005 moles of fuel raises 100 grams of water by 10 degrees, so q is 100 times 4.2 times 10, which is 4,200 joules or 4.2 kilojoules, and per mole that is 4.2 over 0.005, which is 840 kilojoules. Add the calorimetry error: heat escapes to the air and the container, so the experimental value is usually below the data book value, and the fix is a lid, insulation and reading the highest temperature quickly. Finish with catalysts: they lower the activation energy only, leaving the energies of reactants and products unchanged, so the enthalpy change stays the same.
Students do: compute 678 minus 862 themselves and write q together with the value per mole.

If a student writes plus 184, ask which step absorbs and which releases, then decide the order of subtraction.

Scene 3: Collision theory needs two conditions at once: enough energy and the right orientation

State the model: particles must collide, the collision must carry at least the activation energy, and the orientation must be suitable, so not every collision reacts. Show rate with magnesium and acid: 50 cubic centimetres of hydrogen collected in 20 seconds is an average rate of 2.5 cubic centimetres per second; 0.24 grams of magnesium is 0.01 moles, which should give 240 cubic centimetres, and at a steady 2.5 that would take 96 seconds, but the real curve slows because the acid concentration falls, which shows as a falling gradient. Then give the mechanism for each factor: a 10 degree rise lifts the average kinetic energy so far more particles clear the barrier, roughly doubling the rate, so 20 seconds becomes 10; more concentration means more particles per unit volume and more frequent collisions; more surface area exposes more particles, which is why powder beats ribbon; a catalyst offers a path with lower activation energy so a larger share of collisions is effective. Students must use either collision frequency or the proportion of effective collisions, never just the word faster.
Students do: explain with collision theory why magnesium powder reacts faster than ribbon, naming which condition changed.

If a student says powder is faster because it is smaller, ask what is smaller, and which quantity in the collision model that changes.

04 Question types and worked steps

Type Example Steps Answer
Energy diagram Draw the diagram for a combustion reaction and label the enthalpy change Reactants higher, products lower, arrow downwards with a negative value Minus 890 kilojoules per mole
Bond energy Find the enthalpy change of H2 plus Cl2 giving 2HCl Broken 678, formed 862, subtract Minus 184 kilojoules per mole
Calorimetry 0.005 moles of fuel raises 100 grams of water by 10 degrees q equals mc delta T gives 4,200 joules, then divide by moles 840 kilojoules per mole, with heat loss making the experimental value low
Rate factors Explain why heating speeds up a reaction Both collision frequency and the share of energetic collisions rise Both mechanisms are needed for full marks
Sanity check (teach this): Keep three correspondences: diagram heights with the sign of the enthalpy change, broken minus formed with the sign of the answer, and a rate change with collision frequency or the proportion of effective collisions. Apply three sense checks: an exothermic change is always negative, so a positive answer means the direction was reversed; a bond energy difference stays the same order of magnitude as the bond energies, so 678 and 862 can differ by 184 but never by 1,840; and an enthalpy of combustion per mole is usually hundreds to thousands of kilojoules, so 840 is reasonable while 84 means the mole count was misused. Any answer claiming a catalyst releases more heat gets sent back to draw two curves with different activation energies but the same enthalpy change.

05 Independent practice (3 questions)

Question Answer What to watch
Diagram Draw the energy diagram for dissolving ammonium nitrate Check the products sit higher and the change is positive
Calculation Bonds broken total 500 kilojoules and bonds formed 620, find the change Check the answer is minus 120 and described as a net release
Calorimetry How many joules raise 50 grams of water by 4 degrees Check the working uses 50 times 4.2 times 4, giving 840 joules
Explanation Why does a catalyst leave the enthalpy change alone Check the answer says only the activation energy falls

06 Common mistakes and what to say

Mistake Student writes Say this
Direction reversed Writing that a falling temperature means the reaction released heat The water cooled because it handed heat to the reaction, so energy moved from the water into the reaction and the process is endothermic.
Sign written carelessly Computing 184 and writing plus 184 Broken is 678 and formed is 862, so more was released than absorbed, giving minus 184; write both subtotals first and the sign follows.
Catalyst treated as heating Writing that a catalyst makes the reaction release more heat A catalyst only lowers the activation energy, the two energy levels do not move, so the enthalpy change is identical; draw both curves and you will see the same finishing level.
Only one rate mechanism Writing that heating makes particles collide more often and stopping there There is a second half: the share of particles with enough energy also rises, and both are needed for full marks.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
Direction Exothermic is negative with a temperature rise Reversed means act one again
Bond arithmetic Broken minus formed, 678 minus 862 gives minus 184 Wrong sign means act two again
Two collision conditions Enough energy and correct orientation Only one means act three again

09 Tutor FAQ

Must the unit be written with the enthalpy change?

Yes. The number and the unit earn marks together, so minus 184 without kilojoules per mole usually loses a mark; if the question asks per mole, state kilojoules per mole after the value.

Why does calorimetry underestimate the enthalpy change?

Some heat escapes to the air, the container and the thermometer, so the water absorbs less than the reaction released and q is too small; a lid, insulation and a quick reading of the highest temperature reduce the gap.

Does a catalyst shift the position of equilibrium?

No. It speeds the forward and reverse reactions equally, so the system reaches equilibrium sooner while the position and the enthalpy change stay the same.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →