IGCSE Chemistry: Fuels and Polymers Lesson-Prep Guide (for tutors) | Fractional distillation, combustion, cracking and polymers
- 2026-11-16
Students can list the seven fractions yet cannot say why diesel leaves near the bottom of the column, and they turn cracking into polymerisation the moment the words look alike. The marks cluster in three places: the reason for the fraction order, the mole ratio in a combustion calculation, and the repeat unit of a polymer. This lesson fixes all three with 22.8 grams of octane and a polyethene sample of relative molecular mass 5,600.
01 Prerequisites (3-minute check)
If any of these fails, fix it before the lesson starts.
| Skill | Quick check | Pass mark |
|---|---|---|
| Moles and mass | How many moles are there in 44 grams of carbon dioxide? | One mole, dividing mass by relative molecular mass |
| General formulae | What is the general formula of the alkanes? | CnH2n+2, which gives C4H10 |
| Bonding | How many shared pairs are in a carbon to carbon double bond? | Two pairs, and the double bond can open into single bonds |
02 Lesson flow (60 minutes)
| Time | Stage | Tutor does | Student does |
|---|---|---|---|
| 0-6 min | Opening question | Ask why diesel leaves near the bottom and petrol near the top, holding the answer | Write a reason to compare later |
| 6-20 min | Act 1: fractions | Rank the seven fractions by carbon number, boiling point and use | Order them and explain intermolecular forces |
| 20-36 min | Act 2: combustion and cracking | Work 22.8 grams of octane to 140.8 grams of carbon dioxide, then check cracking by mass | Compute the ratio and check both sides balance |
| 36-48 min | Act 3: addition and condensation | Derive 200 repeat units from 5,600 and contrast nylon with starch | Draw the repeat unit and mark where the double bond went |
| 48-54 min | Practice and correction | Set four questions and hunt for answers equating cracking with polymerisation | Work independently and correct errors |
| 54-60 min | Exit check | Ask three core questions | Answer orally, log errors as homework |
03 Teaching script (read it out)
Scene 1: Fractions separate by boiling point, and boiling point follows molecular size
Students do: order the seven fractions and write one reason for each.
If a student says diesel sinks because it is heavy, ask what heavy means at the molecular level and push for carbon number and boiling point.
Scene 2: Combustion has one route: balance, cross by the mole ratio, then convert to mass
Students do: compute the carbon dioxide from 22.8 grams of octane alone and verify the cracking equation by mass.
If a student writes 16 moles of carbon dioxide per mole of octane, send them back to the coefficient 2 and the 2 to 16 ratio.
Scene 3: Two kinds of polymerisation: addition opens a double bond, condensation loses a small molecule
Students do: draw the polyethene repeat unit and derive 200 units from 5,600.
If a student writes the repeat unit as C2H4, point out the double bond has opened and the unit is CH2 to CH2, then have them divide again.
04 Question types and worked steps
| Type | Example | Steps | Answer |
|---|---|---|---|
| Fraction ordering | Rank the seven fractions from top to bottom with reasons | Fix carbon ranges, infer boiling point from intermolecular forces, match to uses | The reason must mention carbon number or molecular size |
| Combustion calculation | Carbon dioxide from 22.8 grams of octane | Balance, find moles, scale by the coefficient ratio, multiply by relative molecular mass | 140.8 grams, cross-checked by the 80 grams of oxygen used |
| Cracking | Crack C10H22 into octane and ethene and show mass is conserved | Left side 142, right side 114 plus 28 | Both sides are 142, and one product carries a double bond |
| Polymer arithmetic | Repeat units in a polyethene of 5,600 | Write the repeat unit mass as 28, then divide | 200 units, and the answer must be a whole number |
05 Independent practice (3 questions)
| Question | Answer | What to watch |
|---|---|---|
| Ordering | Rank kerosene, petrol, diesel and bitumen from top to bottom | Check the reason mentions carbon number, not names |
| Calculation | How many grams of carbon dioxide from 58 grams of butane | Check the moles first, one mole of butane gives four, which is 176 grams |
| Structure | Draw the PVC repeat unit and give its relative mass | Check the chlorine is retained, giving 62.5 |
| Judgement | Which of nylon and polyethene is a condensation polymer | Check the answer mentions losing a small molecule |
06 Common mistakes and what to say
| Mistake | Student writes | Say this |
|---|---|---|
| Cracking called polymerisation | Writing that cracking joins small molecules into big ones | Cracking turns one molecule into several by cutting the chain and leaving a double bond; polymerisation goes the other way. |
| Fraction reason is only density | Writing that diesel sinks because it is dense | Density is the outcome. I want the cause: more carbons, stronger forces between molecules, higher boiling point, so it condenses lower down. |
| Coefficient ignored in combustion | Using 1 to 16 for octane to carbon dioxide | The equation starts with a 2, so 1 to 16 doubles your answer to 281.6 grams. |
| Wrong repeat unit | Writing the polyethene repeat unit as C2H4 | The double bond has opened, so the repeat unit is CH2 to CH2, and 28 is its relative mass rather than the monomer copied across. |
07 Homework (paper, section and question numbers)
- IGCSE Chemistry chapter index — The whole subject at a glance, revisiting acids and electrolysis first
- IGCSE Chemistry: acids, bases and salts — The previous chapter, for more mole practice
- Tutor prep guide index — Same lesson structure in other subjects
08 Exit check (last 5 minutes)
| Question | Answer | Decision |
|---|---|---|
| Seven fractions | Refinery gas, petrol, naphtha, kerosene, diesel, fuel oil, bitumen | Wrong order means act one again |
| One equation | 2C8H18 plus 25O2 gives 16CO2 plus 18H2O | Wrong coefficients mean act two again |
| Two polymerisations | Addition opens a double bond, condensation loses a small molecule | No distinction means act three again |
09 Tutor FAQ
Do students need the carbon ranges?
Core only needs the order and rough ranges, petrol around C5 to C10 and diesel around C14 to C20; Extended asks for the link between carbon number and boiling point, and intermolecular forces remain the answer.
Why is addition polymerisation 100 per cent atom economy?
Every atom of the monomer ends up in the polymer with no by-product, while condensation loses water or hydrogen chloride at each link, so its atom economy falls below 100 per cent.
Is crude oil a pure substance?
No. It is a mixture of many hydrocarbons, which is why it is separated into boiling ranges rather than into single substances, and each fraction is still a mixture.
Find a tutor — freeTutor Registration →
A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.



