/en-tutor-prep-igcse-chemistry-periodic-table-groups-trends/
/en-tutor-prep-igcse-chemistry-periodic-table-groups-trends/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

IGCSE Chemistry — The Periodic Table: Groups and Trends: Lesson-Prep Guide (for tutors) | Electron shells, group trends, formulae and molar volume

IGCSE Chemistry — The Periodic Table: Groups and Trends: Lesson-Prep Guide (for tutors) | Electron shells, group trends, formulae and molar volume

  • 2026-11-17

Students can repeat that elements in a group have similar properties, but when asked why potassium is more reactive than lithium or why iodine is a solid while fluorine is a gas, the answer is often just that it is lower down. This lesson uses electron shells as the only explanation, lays out the Group I melting points from 180 °C to 39 °C and the Group VII boiling points from -188 °C to 184 °C, and finishes with 0.10 mol of sodium giving 1.2 dm3 of hydrogen.

Objectives — Students will be able to: (1) write electron shell arrangements from proton number and read the group from the outer electrons and the period from the number of shells (argon 2,8,8 has 18 electrons and sits in Group 0, period 3); (2) use data to explain Group I melting points falling from lithium 180 °C to rubidium 39 °C and Group VII boiling points rising from fluorine -188 °C to iodine 184 °C, both in terms of forces between particles; (3) write formulae for magnesium oxide, aluminium chloride and sodium sulfide from valency, calculate relative formula masses 40, 133.5 and 78, and find that 0.10 mol of sodium gives 1.2 dm3 of hydrogen.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Atomic structure State the charge on protons, neutrons and electrons Positive, none, negative
Proton number Sodium has proton number 11; how many protons and electrons 11 each
Basic formulae Write the formula of water H2O

02 Lesson flow (45 minutes)

Time Stage Tutor does Student does
0-6 min Diagnostic Three questions: why group members behave alike, why potassium is more reactive than lithium, why iodine is a solid Students answer without tables
6-18 min Act 1: shells give group and period Draw shells from proton number; use argon 2,8,8 to show how to read group and period Students draw sodium, chlorine and argon and label both
18-32 min Act 2: trends backed by data Show Group I melting points 180, 98, 63, 39 °C and Group VII boiling points -188, -34, 59, 184 °C Students calculate the gaps and state the direction
32-40 min Act 3: formulae and molar volume Build MgO from valencies, then relative formula mass and 0.10 mol of sodium Students complete three formulae and one gas volume
40-43 min New context Ask whether the sodium and water equation needs balancing Answer orally with 2Na + 2H2O giving 2NaOH + H2
43-45 min Exit check Collect three questions and sort errors into shells, trends or formulae Independent work

03 Teaching script (read it out)

Scene 1: Act 1: the outer shell decides the group

There is one rule for filling shells: from the inside out, at most 2, then 8, then 8. Sodium has 11 electrons as 2,8,1, so one outer electron puts it in Group I and three shells put it in period 3. Chlorine has 17 electrons as 2,8,7, so seven outer electrons means Group VII. Argon has 18 electrons as 2,8,8, a full outer shell, so it is in Group 0. Emphasise that the group number is not a position label but the count of outer electrons, and that the period number is the number of shells. A full shell is the only meaning of stable here.

Students should say: the group comes from outer electrons, the period from the number of shells.

Scene 2: Act 2: explain trends with forces, not with position

Down Group I the melting points are lithium 180, sodium 98, potassium 63 and rubidium 39 °C, with gaps of 82, 35 and 24: all falling. The atoms get larger, the outer electron is further from the nucleus, the metallic bonding is weaker, so less energy is needed to melt the metal. Reactivity with water increases for the same reason: the outer electron is lost more easily. Group VII runs the other way: fluorine -188, chlorine -34, bromine 59, iodine 184 °C, all rising, because the molecules get larger with more electrons and stronger forces between molecules, so iodine is a solid at room temperature. Opposite directions, one explanation: forces.

Say it as a pair: larger atoms weaken the forces so melting points fall; larger molecules strengthen the forces so boiling points rise.

Scene 3: Act 3: formulae from valency, gas from molar volume

Two steps for a formula: put the metal or positive ion on the left, then swap the valencies as subscripts and simplify if possible. Magnesium two and oxygen two give MgO; aluminium three and chlorine one give AlCl3; sodium one and sulfur two give Na2S. Relative formula mass adds the relative atomic masses: MgO is 24 plus 16, which is 40; AlCl3 is 27 plus three times 35.5, which is 133.5; Na2S is twice 23 plus 32, which is 78. For gases use a molar volume of 24 dm3: 2Na + 2H2O gives 2NaOH + H2, so 0.10 mol of sodium gives 0.05 mol of hydrogen, which is 0.05 times 24, or 1.2 dm3. Always balance the equation first and read the mole ratio before multiplying.

Students should say: swap valencies for the formula, read the mole ratio first, then multiply by 24 dm3.

04 Question types and worked steps

Type Example Steps Answer
Electron shell arrangement Fill 2, 8, 8 from the inside out and write the counts separated by commas
Group and period Outer electrons give the group, the number of shells gives the period
Trend explanation Name the change in size, then the change in forces, then the direction of the melting or boiling point
Writing formulae Positive ion on the left, swap valencies, simplify, then check that charges cancel
Relative formula mass Multiply each relative atomic mass by its subscript and add
Moles and gas volume Balance first, use the coefficients for the mole ratio, then multiply by 24 dm3
Comparing reactivity in a group The more easily the outer electron is lost, the more vigorous the reaction
Sanity check (teach this): The group number is the count of outer electrons, not the last digit of the proton number; Group 0 has a full outer shell and does not react; Group I melting points fall downwards while Group VII boiling points rise, and both are explained by forces; AlCl3 cannot be simplified to AlCl; 0.10 mol of sodium gives 0.05 mol of hydrogen, which is 1.2 dm3, not 2.4 dm3.

05 Independent practice (3 questions)

Question Answer What to watch
Write the electron arrangement of sodium and give its group and period. 2,8,1; Group I, period 3 Naming the outer electrons and shells separately
Which way do Group I melting points change from lithium to rubidium? They fall: 180, 98, 63, 39 °C Writing rise instead of fall
Which way do Group VII boiling points change from fluorine to iodine? They rise: -188, -34, 59, 184 °C Mishandling the negative values
Write the formula of aluminium chloride. AlCl3 Simplifying it to AlCl
What is the relative formula mass of aluminium chloride? 133.5 (27 plus three times 35.5) Forgetting the factor of three
What volume of hydrogen, at room conditions, comes from 0.10 mol of sodium? 1.2 dm3 Assuming a 1 to 1 mole ratio

06 Common mistakes and what to say

Mistake Student writes Say this
Using proton number as the group Sodium has proton number 11, so it is in Group XI The group comes from the outer electrons: sodium has one, so Group I.
Expecting Group 0 to react Argon has eight outer electrons, so it should react easily A full shell is stable, which is why they are called noble gases and do not react.
Not simplifying a formula Magnesium two and oxygen two written as Mg2O2 Simplify whenever possible: MgO.
Ignoring the mole ratio 0.10 mol of sodium giving 0.10 mol of hydrogen The coefficients are 2 to 1, so only 0.05 mol of hydrogen forms.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
What is the electron arrangement of sodium? 2,8,1 Re-teach shell filling in Act 1
How do Group VII boiling points change downwards? They rise, because larger molecules have stronger forces between them Re-teach the forces explanation in Act 2
What volume of hydrogen comes from 0.10 mol of sodium? 1.2 dm3 Re-teach the mole ratio and 24 dm3 in Act 3

09 Tutor FAQ

Why do elements in the same group have similar properties?

They have the same number of outer electrons, and reactions mainly involve outer electrons, so the pattern of reaction is similar. What differs is the size of the atom, which changes how vigorous the reaction is.

How do transition metals differ from Group I?

Transition metals sit in the middle block, have higher melting points and densities, often act as catalysts, form coloured ions in water and can show several oxidation states; Group I metals have one outer electron and only a plus one oxidation state.

When can I use 24 dm3 as the molar volume?

Only for gases at room conditions. If the question states another temperature and pressure, or asks for 22.4 dm3 at standard conditions, use the given value instead of forcing 24.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →