/en-tutor-prep-igcse-chemistry-separation-purity-chromatography/
/en-tutor-prep-igcse-chemistry-separation-purity-chromatography/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

IGCSE Chemistry — Separation Techniques and Purity: Lesson-Prep Guide (for tutors) | Filtration, distillation, chromatography Rf and purity tests

IGCSE Chemistry — Separation Techniques and Purity: Lesson-Prep Guide (for tutors) | Filtration, distillation, chromatography Rf and purity tests

  • 2026-11-17

Students know that filtration separates a solid from a liquid, but ask whether salt water should be distilled or crystallised to recover the salt, or which distance to divide by for an Rf value, and the answers become guesses. This lesson attaches one deciding condition to each of five methods, computes Rf values of 0.45, 0.65 and 0.85 from a paper chromatogram, and closes with a 74.0% recrystallisation yield and a 22 °C boiling point gap.

Objectives — Students will be able to: (1) choose a separation method from two conditions, solubility and boiling point difference, and justify filtration, crystallisation, simple distillation and fractional distillation; (2) calculate Rf from spot height and solvent front height (3.6, 5.2 and 6.8 cm against 8.0 cm give 0.45, 0.65 and 0.85) and use equal Rf to identify the same substance; (3) judge purity from melting point range and yield: a pure solid melts narrowly (135.5 to 136.0 °C) and recovering 18.5 g from 25.0 g of crude product is a 74.0% yield.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Solubility Which dissolves in water, salt or sand Salt dissolves, sand does not
Comparing boiling points Which boils lower, ethanol or water Ethanol at 78 °C
Percentage calculation What percentage is 18.5 of 25.0 74.0%

02 Lesson flow (45 minutes)

Time Stage Tutor does Student does
0-6 min Diagnostic Three questions: how to recover salt from salt water, how to separate sand from salt water, which distance to divide for Rf Students answer without notes
6-18 min Act 1: five methods, two conditions Build a decision table from solubility and boiling point difference Students pick a method for three cases and justify each
18-32 min Act 2: distillation versus fractional distillation Use ethanol 78 °C and water 100 °C, 22 °C apart, to show why a column is needed Students draw the condenser and mark water in and out
32-40 min Act 3: chromatography and purity Rf is spot distance over solvent front distance: 3.6, 5.2, 6.8 against 8.0 Students compute three Rf values and decide identity
40-43 min New context Recover 18.5 g from 25.0 g of crude product and ask for the yield Answer orally: 74.0%
43-45 min Exit check Collect three questions and sort errors into method choice, distillation or Rf Independent work

03 Teaching script (read it out)

Scene 1: Act 1: ask two questions before naming a method

Every separation question starts with two checks: are we keeping the solid or the liquid, and are the two parts soluble in the same solvent. Sand and salt water go through filtration because sand is insoluble. Salt and water go through crystallisation or distillation because the salt dissolves and has a far higher boiling point. Two miscible liquids need fractional distillation because their boiling points differ. Coloured substances dissolved in one solvent need chromatography because they adsorb differently on the stationary phase. Teach the conditions, not the names: insoluble means filter, soluble with a large boiling point gap means distil, soluble with close boiling points means fractionate, trace mixtures mean chromatography.

Students should say: ask about solubility first, boiling point difference second, method name last.

Scene 2: Act 2: distillation works on boiling point difference, not on heat

Simple distillation separates a solvent from a non-volatile solute, for example water from salt water. Two device points matter: the thermometer bulb sits at the side arm of the distillation head, and cooling water enters at the bottom and leaves at the top. Fractional distillation separates two miscible liquids: ethanol boils at 78 °C and water at 100 °C, 22 °C apart, so a fractionating column lets you collect fractions. The commonest errors are reversing the cooling water and putting the thermometer into the liquid; that reads the liquid temperature, not the vapour, so the wrong fraction is collected.

Say the two rules: the thermometer reads vapour, and cooling water goes in at the bottom.

Scene 3: Act 3: Rf is a ratio, so it has no unit

In paper chromatography, the distance a spot moves from the start line divided by the distance the solvent front moves from the same line is the Rf value. With a solvent front of 8.0 cm and spots at 3.6, 5.2 and 6.8 cm, the Rf values are 0.45, 0.65 and 0.85. Rf is a ratio between 0 and 1 with no unit. To decide whether two samples contain the same substance, compare Rf on the same plate, not the depth of colour. Purity has two tests: a narrow melting point range, for example 135.5 to 136.0 °C, only 0.5 °C wide, means pure; a low and wide range means impurities. Yield is the mass recovered divided by the starting mass: 18.5 divided by 25.0 gives 74.0%.

Students should say: Rf is spot distance over front distance, no unit, and equal only on the same plate.

04 Question types and worked steps

Type Example Steps Answer
Method choice Ask about solubility, then boiling point difference, then name the method
Apparatus spotting Check the thermometer position, the cooling water direction and whether the filter paper sits in the funnel
Rf calculation Divide spot distance by solvent front distance and give a decimal between 0 and 1
Identity decision Same plate and same Rf means the same substance
Purity decision A narrow melting point range means pure; low and wide means impure
Yield calculation Recovered mass over starting mass, times 100, in the same units
Distillation versus fractionation Simple distillation collects one fraction; a column separates several
Sanity check (teach this): Rf always lies between 0 and 1 and has no unit; measuring the spot height instead of the solvent front gives 1.00; a wide melting range does not mean pure; yield is a mass ratio, not a volume ratio; cooling water enters at the bottom and leaves at the top.

05 Independent practice (3 questions)

Question Answer What to watch
Solvent front 8.0 cm and spot 3.6 cm: what is Rf? 0.45 Dividing 8.0 by 3.6 to get 2.22
Spots with Rf 0.45, 0.65 and 0.85: how many substances? Three, because all three Rf values differ Treating similar colours as one substance
Recovering 18.5 g from 25.0 g of crude product: what is the yield? 74.0% Dividing 25.0 by 18.5
Which method recovers water from salt water? Simple distillation Answering crystallisation
How far apart are the boiling points of ethanol and water? 22 °C (100 minus 78) Writing 178 or a negative value
What should the melting range of a pure solid look like? Narrow, for example 0.5 °C wide Saying that a higher melting point always means purer

06 Common mistakes and what to say

Mistake Student writes Say this
Dividing the wrong way for Rf Taking 8.0 divided by 3.6 to get 2.22 The spot distance is on top and the solvent front below, so 3.6 over 8.0 gives 0.45.
Reversing the cooling water Running water in at the top and out at the bottom because it looks tidier Water must enter at the bottom and leave at the top so the condenser stays full.
Assuming a higher melting point means purer A melting point of 140 °C must be purer than 136 °C Purity is shown by a narrow range, not by a high value; impurities usually lower the melting point and widen the range.
Using a volume for yield Dividing 25.0 mL by 18.5 g Yield compares mass with mass, so the units must match.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
Does Rf have a unit? No, it is a ratio between 0 and 1 Re-teach Act 3
How should the cooling water be connected? In at the bottom, out at the top Re-teach the apparatus in Act 2
What is the yield for 18.5 g from 25.0 g? 74.0% Re-teach the yield definition

09 Tutor FAQ

Why use chromatography rather than distillation to identify dyes?

Dyes are present in tiny amounts, have high boiling points and often decompose on heating. Chromatography works at room temperature and separates substances by how they distribute between a stationary and a moving phase, then Rf values identify them.

Do Rf values change with conditions?

Yes. The same substance can give different Rf values with a different solvent, a different paper or a different temperature, so identity comparisons must use one plate, one solvent and one run, not values copied from a textbook.

Both crystallisation and distillation can recover a solid from salt water, so which do I choose?

To recover the salt, crystallise: boil off some water, then cool so crystals form. To recover the water, distil. If the question asks for the solute, write crystallisation; if it asks for the solvent, write distillation.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →