/en-tutor-prep-igcse-maths-cumulative-frequency-box-plots/
/en-tutor-prep-igcse-maths-cumulative-frequency-box-plots/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

IGCSE Maths | Cumulative Frequency and Box Plots | Reading Q1, Q3 and IQR, Comparing Two Distributions

IGCSE Maths | Cumulative Frequency and Box Plots | Reading Q1, Q3 and IQR, Comparing Two Distributions

  • 2026-11-16

Students often plot each group frequency instead of the running total, then try to read a quartile by counting the tenth student. Both moves wreck the box plot, so fix the table and the reading method before anything else.

Objectives — Students can: (1) build a cumulative frequency table and plot the cumulative frequency curve; (2) read Q1, the median and Q3 where the cumulative frequency equals n/4, n/2 and 3n/4, then find the interquartile range as Q3 minus Q1; (3) draw a box plot from the five values; (4) compare two distributions using medians and interquartile ranges, and check the 1.5 x IQR fences for outliers.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Grouped frequency tables Build a table from raw data IGCSE statistics basics
Median position Use position (n+1)/2 S1 statistics
Proportional reading Estimate a value inside a group New in this lesson

02 Lesson flow (45 minutes)

Time Stage Tutor does Student does
0-6 min Diagnose Ask what a cumulative frequency of 20 means The 20th of 40 students
6-18 min Table and curve Add each frequency to the running total, plot at upper bounds Curve runs from (0,0) to (50,40)
18-30 min Read Q1, median, Q3 Horizontal from n/4, n/2, 3n/4 to the curve, then down Values match the interpolation
30-40 min Draw the box plot Five values plus the 1.5 x IQR fences Box and whiskers correct
40-45 min Exit check Three questions All correct

03 Teaching script (read it out)

Scene 1: Act 1: cumulative frequency is a running total, not a group count

Start from the frequencies 2, 6, 12, 14, 6 and write 2, 8, 20, 34, 40 underneath. Say plainly that each entry counts everyone at or below that upper bound, so the last entry must equal the total of 40. Plot each point at the upper bound (10, 20, 30, 40, 50) and join with a smooth curve from the origin, because nobody scored below 0. Students who plot at class midpoints get a curve that reads every quartile too low.

Tutor line: “Cumulative means how many so far, not how many in this group. The last number must be 40, or you added wrong.”

Scene 2: Act 2: quartiles are read on the cumulative frequency axis

With n = 40, read horizontally at cumulative frequencies 10, 20 and 30. The curve gives about 21.9, 30.4 and 37.7 marks, so the interquartile range is about 15.8. Students must write the interpolation line, since the mark scheme awards the method mark separately. Warn them not to hunt for “the tenth student”, because individual scores are not in a grouped table.

Tutor line: “Do not look for the tenth student. Go to 10 on the vertical axis, across to the curve, then straight down.”

Scene 3: Act 3: a box plot exists to compare two sets

Five values: minimum 3, Q1 21.9, median 30.4, Q3 37.7, maximum 48. The lower fence is 21.9 minus 23.7, below zero, and the upper fence is 61.4, so none of the 40 scores is an outlier and both whiskers reach the end values. When comparing two classes, say one sentence about the median and one about the box width; the interquartile range describes the middle half, so a narrow box means consistency, not high marks.

Tutor line: “Two sentences only: whose median is higher, and whose box is narrower. Narrow means the middle half is bunched, not that the class is better.”

04 Question types and worked steps

Type Example Steps Answer
Build the cumulative table Add each frequency to the running total, check the last entry Last entry equals n
Read quartiles from the curve Mark n/4, n/2, 3n/4 on the vertical axis, across then down Show the interpolation
Find and interpret the IQR IQR equals Q3 minus Q1 A larger IQR means a wider middle half
Compare two box plots Compare medians, IQRs and ranges Two comparisons are needed for full marks
Sanity check (teach this): Extended IGCSE only needs linear interpolation from grouped data, not exact quartiles from raw values, so answers may vary slightly if the working is shown. The specified outlier rule is 1.5 x IQR; do not bring in standard deviation or z-scores, which belong to A-Level. Box plots are always drawn on the same scale as the data axis.

05 Independent practice (3 questions)

Question Answer What to watch
What must the last entry of the cumulative table be? 40, the total n Running total check
Estimate the median score. About 30.4 marks Read at cumulative frequency 20
Find Q1 and Q3. About 21.9 and 37.7 Read at 10 and 30
Find the interquartile range. About 15.8 marks 37.7 minus 21.9
How many students scored 35 or more? 13 students, 32.5% Cumulative frequency at 35 is 27, so 40 minus 27

06 Common mistakes and what to say

Mistake Student writes Say this
Plotting group frequencies The curve is flat or jagged and every quartile is wrong “Each point is the total so far, so the curve only goes up.”
Counting students to find a quartile Guessing a score instead of reading the curve “Vertical axis first, then across, then down.”
Missing the origin or the last point The curve starts at (10, 2) and ends at (50, 34) “Start at (0,0), finish at the top bound with n.”
Comparing box plots without the IQR Only half the marks “One sentence on the median, one on the box width.”

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
What does a cumulative frequency table show? How many values lie at or below each upper bound, so quartiles can be read Reteach Act 1
For n = 60, which cumulative frequency gives Q1? 15, which is n/4 Reteach the position rule
IQR is 20 and Q1 is 12, so what is Q3? 32 Reteach the formula

09 Tutor FAQ

Why include the point (0, 0)?

Cumulative frequency counts values at or below a score, and nobody scores below zero, so the curve must start at the origin. Without it the curve begins at the first upper bound and the lower quartile reads too high.

Do answers have to be decimals?

When the question says estimate, one decimal place is plenty, provided the interpolation is written down. Answers within about half a mark of the interpolated value are normally accepted.

Should outliers always be marked?

Only when a point falls outside the 1.5 x IQR fences. In this data set both fences lie outside the range, so there are no outliers and the whiskers simply reach the minimum and maximum.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →