IGCSE Maths | Mensuration: cones, spheres and pyramids prep guide (for tutors) | Slant height, surface area, scaling
- 2026-11-16
Students can recite that a sphere is four thirds pi r cubed, then lose the base circle on a cone and use the sloping edge instead of the slant height on a pyramid. This chapter splits every formula into which length it needs, and pins the one third with a cylinder.
01 Prerequisites (3-minute check)
If any of these fails, fix it before the lesson starts.
| Skill | Quick check | Pass mark |
|---|---|---|
| Circle area and circumference | Work out the area of a circle of radius 5 | 78.54 square centimetres |
| Pythagoras | Find the hypotenuse from 5 and 12 | 13 |
| Squares and cubes | Work out 6 squared and 6 cubed | 36 and 216 |
02 Lesson flow (45 minutes)
| Time | Stage | Tutor does | Student does |
|---|---|---|---|
| 0-6 min | Diagnostic | Asks what fraction of a cylinder a cone fills, and for the formula on paper | Writes an answer without the book |
| 6-18 min | Cone | Finds slant height 13 from radius 5 and height 12, then works through each part | Gets curved 204.20, total 282.74, volume 314.16 |
| 18-30 min | Sphere and hemisphere | Uses radius 6 for sphere volume 904.78 and surface 452.39, then halves | Gets hemisphere volume 452.39 and surface 339.29 |
| 30-38 min | Pyramid | Base 6 with height 4, finds face slant height 5, then lateral and total area | Produces volume 48, lateral 60, total 96 |
| 38-45 min | Exit check | Collects three items and marks at once | Works independently |
03 Teaching script (read it out)
Scene 1: Scene one: a cone needs the slant height before any area
Ask one student to restate the rule in their own words before moving on.
Scene 2: Scene two: a hemisphere adds a base circle
Ask one student to restate the rule in their own words before moving on.
Scene 3: Scene three: on a pyramid the face slant height is not the sloping edge
Ask one student to restate the rule in their own words before moving on.
04 Question types and worked steps
| Type | Example | Steps | Answer |
|---|---|---|---|
| Cone | Find the slant height from radius and height, then separate curved, base, total surface and volume with the right units | ||
| Sphere and hemisphere | Use four thirds pi r cubed and four pi r squared; a hemisphere halves the volume but adds a base circle to reach 3 pi r squared | ||
| Pyramid | Find base area and volume first, then the face slant height for the four triangles, then add the base | ||
| Similar solid scaling | State the length ratio, square it for area and cube it for volume, then verify with measured numbers |
05 Independent practice (3 questions)
| Question | Answer | What to watch |
|---|---|---|
| A cone has radius 5 and height 12. What is its slant height? | 13 cm, by Pythagoras | Whether the height was taken as the slant height |
| What is the volume of that cone? | 100 pi, roughly 314.16 cubic centimetres | Whether the one third was dropped |
| What is the total surface area of that cone? | 90 pi, roughly 282.74 square centimetres | Whether the base was left out |
| A sphere has radius 6. Give its volume and surface area. | 288 pi, roughly 904.78 cubic centimetres, and 144 pi, roughly 452.39 square centimetres | Whether the two formulas were swapped |
| What is the surface area of a hemisphere of radius 6? | 108 pi, roughly 339.29 square centimetres, that is 3 pi r squared | Whether the base circle was dropped |
| A square-based pyramid has base 6 and height 4. Give its total surface area. | 96 square centimetres, lateral 60 plus base 36 | Whether the sloping edge replaced the slant height |
06 Common mistakes and what to say
| Mistake | Student writes | Say this |
|---|---|---|
| Hemisphere surface with the curved part only | Answer 2 pi r squared, roughly 226.19 | The cut exposes a circle, so a hemisphere has three circles of surface. |
| Pyramid faces using the sloping edge | Using root 34, roughly 5.83, as the triangle height | The face height is the slant height to the midpoint of an edge, which is 5 cm here. |
| Cone volume without the one third | Answer 300 pi, roughly 942.48 | 942.48 is the cylinder; the cone is a third of it, so 314.16. |
| Volume ratio taken as length ratio | Doubling the radius and answering twice the volume | Length doubles, area quadruples and volume is eight times, as 113.10 and 904.78 confirm. |
07 Homework (paper, section and question numbers)
- IGCSE maths chapter index (trigonometry and sectors) — Questions 1-4
- IGCSE lesson-prep overview (all three subjects) — Questions 1-6
08 Exit check (last 5 minutes)
| Question | Answer | Decision |
|---|---|---|
| What is the volume of a cone with radius 5 and height 12? | 100 pi, roughly 314.16 cubic centimetres | Wrong: reteach scene one the one third |
| What is the surface area of a hemisphere of radius 6? | 108 pi, roughly 339.29 square centimetres | Wrong: reteach scene two the base circle |
| Two similar solids have a length ratio of 2. What is their volume ratio? | 8 | Wrong: reteach scene three scaling |
09 Tutor FAQ
Why is a cone one third of a cylinder?
Three cones of the same base and height fill one cylinder exactly, so each cone holds a third. Check with radius 5 and height 12: the cylinder is 300 pi, roughly 942.48, and the cone is 100 pi, roughly 314.16.
When do I use the slant height and when the height?
Surface area uses the slant height, the length lying along the surface; volume uses the perpendicular height. For a cone the slant height runs from apex to rim, for a pyramid from apex to the midpoint of a base edge, and both come from Pythagoras.
How many decimal places should the answer carry?
IGCSE convention is three significant figures unless the question states otherwise, so 314.16 is usually written as 314. Exact values in terms of pi are worth showing alongside, because they cannot be marked down for rounding.
Find a tutor — freeTutor Registration →
A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.



