IGCSE Maths | Trigonometry: Sine Rule, Cosine Rule and Bearings — Lesson-Prep Guide for Tutors | 60-minute flow, worked steps, four common mistakes
- 2026-11-16
Students reach for the sine rule whenever they see three sides and an angle, then produce a sine of 1.4 and copy it down. Bearings go wrong the same way, with the back bearing written as the same reading. Marks cluster in three places: choosing the rule, leaving the calculator in radian mode, and forgetting to reduce a bearing past 360 degrees. This lesson fixes the choice with 12 cm opposite 40 degrees and with 8 cm and 11 cm enclosing 35 degrees.
01 Prerequisites (3-minute check)
If any of these fails, fix it before the lesson starts.
| Skill | Quick check | Pass mark |
|---|---|---|
| Pythagoras | With one leg 5 and hypotenuse 13, what is the other leg? | 12, from 169 minus 25 and a square root |
| Angle sum | With A equals 40 degrees and B equals 65 degrees, what is C? | 75 degrees, from 180 minus both angles |
| Calculator mode | What should sine 30 give? | 0.5, with DEG showing on the screen |
02 Lesson flow (60 minutes)
| Time | Stage | Tutor does | Student does |
|---|---|---|---|
| 0-5 min | Prerequisite check | Write three quick checks, take oral answers, and keep anyone who gets sine 30 as 0.017 at the board to press it again | Open the calculator, give three answers, point at the DEG indicator |
| 5-15 min | Right-angled ratios | Draw a 5-12-13 triangle, label each side, write sine around 0.3846, cosine around 0.9231 and tangent around 0.4167, and stress that the hypotenuse is always longest | Fill the three ratios on the sheet and write the line about three known sides |
| 15-30 min | Sine rule | Introduce the rule from the biggest angle sitting opposite the longest side, then solve b from 12 cm opposite 40 degrees in three lines: find the pair, write the ratio, solve | Copy once, then find C equals 75 degrees themselves and note that a matched pair is required |
| 30-42 min | Cosine rule | Show 8 cm and 11 cm enclosing 35 degrees, stress the minus sign and that cosine only takes the enclosed angle, and reach c squared 40.83 so c is about 6.4 | Press the calculator again, copy 40.83 and 6.4, and note that the answer must be below 19 |
| 42-52 min | Area and bearings | Use area equals half a b sine C to get 25.2 square centimetres, then draw a bearing of 070 degrees and a back bearing of 250 degrees, including the case that passes 360 | Draw one bearing diagram, mark north and 70 degrees clockwise, and write the back bearing |
| 52-60 min | Practice and exit check | Hand out three exit questions, collect them, and note who chose the wrong rule | Complete three questions independently and check the DEG indicator before handing in |
03 Teaching script (read it out)
Scene 1: Act one: three sides become three ratios
Ask the student to say once: the hypotenuse is longest, so sine and cosine stay below 1.
Scene 2: Act two: choose the rule by the data
Ask the student to restate: two sides with an enclosed angle means cosine, a matched pair means sine, and a sine above 1 means the wrong rule.
Scene 3: Act three: bearings and elevation are the same triangle
Ask the student to restate: bearings run clockwise from north, the back bearing adds 180, and past 360 you subtract 360.
04 Question types and worked steps
| Type | Example | Steps | Answer |
|---|---|---|---|
| Right-angled ratios | Legs 5 and 12 with hypotenuse 13 | Identify opposite, adjacent and hypotenuse, then write sine, cosine and tangent | Sine around 0.3846, cosine around 0.9231, tangent around 0.4167 |
| Sine rule for a side | A equals 40 degrees, B equals 65 degrees, a equals 12 cm | Find C equals 75 degrees, write a over sine A equals b over sine B, then solve | b is about 16.9 cm |
| Cosine rule for the third side | a equals 8 cm, b equals 11 cm, enclosed C equals 35 degrees | Write c squared as 64 plus 121 minus 2 times 8 times 11 times cosine 35, then take the root | c squared is about 40.83 and c is about 6.4 cm |
| Bearings and elevation | Bearing of B from A is 070 degrees; elevation 35 degrees at 20 metres | Add 180 to the back bearing and reduce modulo 360; height is horizontal distance times tangent of the elevation | Back bearing 250 degrees; height about 14.0 metres |
05 Independent practice (3 questions)
| Question | Answer | What to watch |
|---|---|---|
| Hypotenuse 13 and one leg 5: find the other leg and the three ratios | Other leg 12; sine around 0.3846, cosine around 0.9231, tangent around 0.4167 | Watch whether the hypotenuse is identified before any fraction is written |
| A equals 40 degrees, B equals 65 degrees, a equals 12 cm: find b | b is about 16.9 cm | Check that C equals 75 degrees is filled in first and that each ratio pairs a side with its own angle |
| a equals 8 cm, b equals 11 cm, C equals 35 degrees: find c and the area | c about 6.4 cm; area about 25.2 square centimetres | Check that the minus sign survived and that the area used half a b sine C |
| Back bearing of 070 degrees; elevation 35 degrees at 20 metres | Back bearing 250 degrees; height about 14.0 metres | Check the clockwise direction and that tangent, not sine, was used for the height |
06 Common mistakes and what to say
| Mistake | Student writes | Say this |
|---|---|---|
| Sine rule used with two sides and an enclosed angle | Sine B comes out as 1.4 and is copied as the answer | Two sides with an enclosed angle means the cosine rule; the sine rule needs a matched pair of side and angle. |
| Calculator left in radian mode | Sine 40 gives 0.017 and every later answer is far too small | Check the indicator for DEG before the first calculation, and press DRG once if it is missing. |
| Missing minus sign in the cosine rule | c squared written as 64 plus 121 plus 144.17, giving 18.1 | The middle sign is a minus, because cosine only takes the enclosed angle and a larger angle shortens the third side. |
| Bearing above 360 kept as written | 070 plus 180 written as 430 degrees | If adding 180 passes 360, subtract 360, because a bearing only runs from 0 to 360. |
07 Homework (paper, section and question numbers)
- IGCSE Maths: algebra and quadratics guide — The previous chapter on rearranging and solving, needed here
- IGCSE Maths: circle theorems and sectors guide — The same angle reasoning, worth revising side by side
- IGCSE Maths lesson-prep index — Order of the other chapters and their practice
08 Exit check (last 5 minutes)
| Question | Answer | Decision |
|---|---|---|
| A equals 50 degrees, B equals 60 degrees, a equals 10 cm: find b | b is about 11.3 cm | A miss here means the sine rule pairing is shaky, so reteach act two |
| a equals 6, b equals 7, C equals 60 degrees: find c | c squared is 43 and c is about 6.6 | A miss here means the minus sign is not secure, so reteach step four |
| Elevation 30 degrees at 15 metres: find the height | Height about 8.7 metres | A miss here means tangent and sine are still confused, so reteach act three |
09 Tutor FAQ
Which level does this chapter suit?
This is Extended trigonometry, usually taught in years nine and ten; Core students only need the right-angled ratios and simple bearings, while the sine and cosine rules belong to Extended.
Is 60 minutes enough for four question types?
Yes, but the flow gives 15 minutes to the sine rule and 12 to the cosine rule, leaving only 8 minutes of independent practice; if the prerequisite check fails, set the area and bearings work as homework rather than shortening act two.
Is there matching practice?
The homework links to the algebra and circle theorem chapters on this site, where the practice pages carry answers so students can check by question number and close the loop from prep to practice to marking.
Find a tutor — freeTutor Registration →
A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.



