S2 Geography Mass movement and slope failure Paper 1
- 2026-11-18
S2 Geography Mass movement and slope failure Paper 1
Ten basic items on the definition of mass movement, gradient percentages, rainfall rates and factor of safety.
Mass movement basics Start from gravity, slope angle and water, separate falls, slides, flows and creep, then use simple calculations for gradient and factor of safety.
01 Paper details (check answers afterwards)
| Item | Detail |
|---|---|
| Questions | 10 |
| Suggested time | 25 |
| Difficulty mix | Foundation 4 · Intermediate 2 · Challenge 2 · Error redo 2 |
| Chapter | Chapter: S2 Geography: Mass movement and slope failure |
| Level | Basic |
02 Questions (10 items)
- FoundationWhat is mass movement?
- FoundationA slope rises 15 metres over a horizontal distance of 100 metres. What is the gradient as a percentage?
- FoundationOn the same soil, which is more likely to fail, a 25 degree slope or a 40 degree slope?
- FoundationA rainstorm drops 150 mm in three hours. What is the average hourly rainfall?
- IntermediateA slope has resisting force 90 kN and driving force 60 kN. What is the factor of safety?
- IntermediateA landslide moves 400 cubic metres of debris at 2.5 tonnes per cubic metre. What is its mass?
- ChallengeA debris flow travels at 6 metres per second toward a village 240 metres away. How many seconds until it arrives?
- ChallengeOf the four types of mass movement, which moves most slowly?
- Error redoWhat mainly distinguishes a fall, a slide and a debris flow?
- Error redoWhich of these is not a necessary condition for mass movement?
03 Answers and one-line notes
| # | Answer | One-line note |
|---|---|---|
| 1 | The downslope movement of rock and soil under gravity. | Mass movement is driven by gravity rather than by running water or wind, so the material moves as a body or a mass. |
| 2 | 15 per cent. | 15 divided by 100 times 100 is 15, since gradient is rise divided by horizontal run. |
| 3 | The 40 degree slope. | Tan 40 degrees is about 0.84 against 0.47 for 25 degrees, so the steeper slope has a much larger downslope component. |
| 4 | 50 mm per hour. | 150 divided by 3 is 50, and short intense bursts are the commonest trigger of slope failure. |
| 5 | 1.5. | 90 divided by 60 is 1.5, and a factor of safety above 1 means resisting force exceeds the driving force. |
| 6 | 1,000 tonnes. | 400 times 2.5 is 1,000, multiplying volume by density to get mass. |
| 7 | 40 seconds. | 240 divided by 6 is 40, so a fast debris flow leaves almost no time to evacuate. |
| 8 | Creep. | Creep shifts only millimetres to centimetres a year, while falls and debris flows are measured in seconds. |
| 9 | Their water content and the way the material moves. | A fall drops free blocks, a slide moves as one mass along a slip plane, and a debris flow behaves as a water-laden fluid. |
| 10 | Strong wind. | Steep slope, loose material and water are the three conditions, and wind only affects the rate of weathering. |
04 What to do after marking
- After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
- Repeat the same item two days later; move to the next paper only when both attempts are correct.
- Parents only need the answer and note columns; there is no need to explain every item.
Download the full ten-item paper as a PDF, answers and notes included.Tutor Registration →
Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.



