/en-tutor-prep-s2-ict-data-representation-binary-practice-4/
/en-tutor-prep-s2-ict-data-representation-binary-practice-4/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Paper 4: Ten common mistakes corrected one by one

Paper 4: Ten common mistakes corrected one by one

  • 2026-11-21

Paper 4: Ten common mistakes corrected one by one

Chapter practice with ten items, answers and a one-line note for each, about 25 minutes.

Paper 4 Ten items on this chapter with answers for immediate marking.

01 Paper details (check answers afterwards)

Item Detail
Questions 10
Suggested time 25
Difficulty mix Foundation 4 · Intermediate 2 · Challenge 2 · Error redo 2
Chapter Chapter: S2 ICT: data representation (binary)
Level Retry

02 Questions (10 items)

  1. FoundationCorrect the error: binary may use the digits 0, 1 and 2.
  2. FoundationCorrect the error: 1 KiB equals 1000 bytes.
  3. FoundationCorrect the error: a bit is larger than a byte.
  4. FoundationCorrect the error: denary 10 is written as binary 101.
  5. IntermediateCorrect the error: hexadecimal uses only 0 to 9.
  6. IntermediateCorrect the error: the largest unsigned eight-bit value is 256.
  7. ChallengeCorrect the error: a higher resolution always means a bigger file.
  8. ChallengeCorrect the error: 1 MB equals 1 MiB.
  9. Error redoCorrect the error: each ASCII character takes 2 bytes.
  10. Error redoCorrect the error: 1021 is a valid binary number.

03 Answers and one-line notes

# Answer One-line note
1 Binary uses only 0 and 1. A digit 2 would mean a base-three system, not binary.
2 1 KiB equals 1024 bytes. Binary prefixes step by 1024, while 1000 belongs to the decimal prefix kB.
3 A bit is smaller than a byte. The bit is the smallest unit, and eight bits make one byte.
4 The correct form is 1010. 8 plus 2 gives 10, so the 2 place must be set; dropping it gives 5 instead.
5 Hexadecimal uses 0 to 9 plus A to F. A to F stand for 10 to 15, completing sixteen digit symbols.
6 The largest is 255, out of 256 possible values. Values start at zero, so the maximum is 2 to the power 8 minus 1, which is 255.
7 File size depends on both pixel count and colour depth. Many pixels at low colour depth can still be smaller than few pixels at high colour depth.
8 1 MB is 1,000,000 bytes while 1 MiB is 1,048,576 bytes. MB is a decimal prefix and MiB a binary prefix, so they differ by about five per cent.
9 Each ASCII character takes 1 byte. Standard ASCII needs 7 bits per character, stored in one byte.
10 1021 is not a valid binary number. Binary allows only 0 and 1, so any digit 2 means the carrying was written wrongly.

04 What to do after marking

  • After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
  • Repeat the same item two days later; move to the next paper only when both attempts are correct.
  • Parents only need the answer and note columns; there is no need to explain every item.

Want the whole chapter? See all four difficulty papers on the chapter page.Tutor Registration →

Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →