S2 Science Magnets: Retry the Common Mistakes
- 2026-11-22
← Back to the Secondary Science chapter index
S2 Science Magnets: Retry the Common Mistakes
Fix ten typical mistakes, including like poles attracting, field lines leaving S, magnetism after switch-off and cutting for a single pole.
Fix ten typical mistakes, including like poles attracting, field lines leaving S, magnetism after switch-off and cutting for a single pole. Fix ten typical mistakes, including like poles attracting, field lines leaving S, magnetism after switch-off and cutting for a single pole.
01 Paper details (check answers afterwards)
| Item | Detail |
|---|---|
| Questions | 10 questions |
| Suggested time | 25 minutes |
| Difficulty mix | Error redo 10 |
| Chapter | Chapter: S2 Science – Magnets and Electromagnets |
| Level | S2 . magnetism retry |
02 Questions (10 items)
- Error redoA student thinks two N poles attract each other. What actually happens?
- Error redoA student draws field lines leaving the S pole and entering the N pole. What is wrong?
- Error redoA student thinks copper and aluminium are attracted by magnets if the pieces are big enough. What is wrong?
- Error redoA student thinks an electromagnet keeps its magnetism after the current stops. What is true for a soft iron core?
- Error redoA student thinks cutting a magnet gives a half with only an N pole. What is wrong?
- Error redoA student thinks increasing the current weakens an electromagnet. What is correct?
- Error redoA student thinks adding turns has no effect on an electromagnet. What is wrong?
- Error redoA student thinks an electromagnet is magnetic without a power supply, like a permanent magnet. What is wrong?
- Error redoA student thinks a magnet must touch a nail before it can attract it. What is correct?
- Error redoA student thinks a steel core is better than soft iron because its magnetism lasts. What is wrong?
03 Answers and one-line notes
| # | Answer | One-line note |
|---|---|---|
| 1 | Like poles repel, so two N poles push apart | Like poles repel and unlike poles attract, so N against N always pushes away. |
| 2 | Outside the magnet the lines leave N and enter S | Field direction is the force on an N pole, so outside the magnet the lines run from N to S. |
| 3 | Copper and aluminium are not magnetic at any size | Only magnetic materials such as iron, cobalt and nickel are attracted, whatever their size. |
| 4 | The magnetism disappears immediately | A soft iron core is magnetised only while current flows, which is what makes it switchable. |
| 5 | Poles cannot exist alone; every piece still has both poles | However small the piece, each one has both poles; a single isolated pole has never been found. |
| 6 | A larger current gives a stronger magnet | Strength is proportional to current, so doubling the current roughly doubles the strength. |
| 7 | More turns give a stronger magnet, in proportion to the turns | Each turn adds field, so more turns mean more ampere-turns and a stronger magnet. |
| 8 | An electromagnet is magnetic only while current flows | The current creates the field, so with no current there is no magnetism. |
| 9 | Magnetic force acts at a distance without contact | The field fills the space around the magnet, so it attracts through paper or air. |
| 10 | An electromagnet must switch off, and steel stays magnetised after the current stops | Steel is hard to demagnetise and would keep holding the load, so electromagnets use soft iron. |
04 What to do after marking
- After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
- Repeat the same item two days later; move to the next paper only when both attempts are correct.
- Parents only need the answer and note columns; there is no need to explain every item.
Join our S2 Science courseTutor Registration →
Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.



