S2 Science Circuits: Retry the Common Mistakes
- 2026-11-22
← Back to the Secondary Science chapter index
S2 Science Circuits: Retry the Common Mistakes
Fix ten typical errors: assuming current shrinks along a series loop, adding parallel voltages and wiring an ammeter in parallel.
Fix ten typical errors: assuming current shrinks along a series loop, adding parallel voltages and wiring an ammeter in parallel. Fix ten typical errors: assuming current shrinks along a series loop, adding parallel voltages and wiring an ammeter in parallel.
01 Paper details (check answers afterwards)
| Item | Detail |
|---|---|
| Questions | 10 questions |
| Suggested time | 25 min |
| Difficulty mix | Error redo 10 |
| Chapter | Chapter: S2 Science – Simple Circuits: Series and Parallel |
| Level | S2 . circuits retry |
02 Questions (10 items)
- Error redoSomeone says the current shrinks after passing the first bulb in a series circuit. Is that right?
- Error redoSomeone says the voltages of parallel branches add up. Is that right?
- Error redoSomeone puts two 1.5 V cells in parallel expecting 3 V. Is that correct?
- Error redoSomeone thinks two resistors in parallel give a total larger than either one. Is that correct?
- Error redoSomeone connects an ammeter in parallel with the circuit. Is that correct?
- Error redoSomeone connects a voltmeter in series with the circuit. Is that correct?
- Error redoSomeone works out the current for 6 V across 3 ohm as 18 A. What went wrong?
- Error redoSomeone thinks the other bulbs still light when one bulb fails in a series circuit. Is that correct?
- Error redoSomeone says a 100 W appliance uses 1000 kWh in 10 hours. What is the correct figure?
- Error redoSomeone adds reciprocals to find a series total. What is the correct method?
03 Answers and one-line notes
| # | Answer | One-line note |
|---|---|---|
| 1 | No, the current is the same everywhere | A series circuit has one path and charge is not used up, so the current stays the same. |
| 2 | No, every branch has the same voltage | Parallel branches share the same two nodes, so their voltages are equal to the supply voltage. |
| 3 | No, it stays at 1.5 V | Parallel connection raises the available current and capacity, not the voltage. |
| 4 | No, the total is smaller than the smallest | Two 4 ohm resistors in parallel give 2 ohm, always below the smallest resistor. |
| 5 | No, the ammeter belongs in series | An ammeter has almost no resistance, so in parallel it would draw a huge current; it must be in series. |
| 6 | No, the voltmeter belongs in parallel | A voltmeter has very high resistance, so in series it would stop the current; it measures across two points. |
| 7 | The values were multiplied; it should be 2 A | Current is voltage divided by resistance, and 6 divided by 3 gives 2 A. |
| 8 | No, all the other bulbs go out | One path means a single break stops the current, so every bulb goes out. |
| 9 | 1 kWh | 0.1 kW times 10 hours gives 1 kWh, not 1000 kWh. |
| 10 | Add the resistances directly | Series resistances add directly; only parallel combinations use reciprocals. |
04 What to do after marking
- After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
- Repeat the same item two days later; move to the next paper only when both attempts are correct.
- Parents only need the answer and note columns; there is no need to explain every item.
Join our S2 Science courseTutor Registration →
Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.



