/en-tutor-prep-s2-science-states-of-matter-melting-boiling/
/en-tutor-prep-s2-science-states-of-matter-melting-boiling/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Junior Science | Changes of State Prep Guide (for tutors) | Melting, boiling and heating curves

Junior Science | Changes of State Prep Guide (for tutors) | Melting, boiling and heating curves

  • 2026-11-18

Students can say ice turns into water, but ask why the thermometer stops rising while the ice melts and the room goes quiet. This chapter turns one everyday observation into three numbers: specific heat for warming, latent heat of fusion for melting, latent heat of vaporisation for boiling.

Objectives — By the end students can: (1) describe particle arrangement and motion in the three states and state that melting and boiling points are fixed for a pure substance; (2) use specific heat capacity to find that heating 0.5 kg of water from 20 to 100 degrees needs 168 kJ; (3) use the latent heat of fusion to find that melting 0.5 kg of ice takes 167 kJ and explain the flat section of a heating curve; (4) compare 167 kJ for melting with 1130 kJ for vaporising the same mass and say vaporising costs more than six times as much.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Particle model Magnify a glass of water ten million times, what do you see Particles in constant motion with gaps between them
Units How many joules are in one kilojoule One thousand, so 168000 J is 168 kJ
Reading a graph On a temperature-time graph, what does a flat section mean Temperature is constant while heating continues

02 Lesson flow (60 minutes)

Time Stage Tutor does Student does
0-6 minutes Open with a beaker of ice Read the thermometer as it rises then holds Write down where it stops
6-16 minutes Particles in three states Fixed lattice, sliding, free Draw three particle diagrams
16-28 minutes Melting and boiling points Fixed for pure substances, a range for mixtures Classify three samples
28-42 minutes Two energy equations Specific heat for warming, latent heat for changing state Work out 168 kJ and 167 kJ
42-54 minutes Heating curve and vaporisation Four slopes and two plateaus Label the plateaus and explain
54-60 minutes Exit check Three oral questions Answer orally or in writing

03 Teaching script (read it out)

Scene 1: Let the class watch the temperature stop

Put crushed ice in a beaker, stand a thermometer in it and read every thirty seconds. The reading climbs below zero, reaches 0, then holds while the ice keeps melting, and only climbs again once every last bit of ice has gone.
Compress that into one sentence: heating is not the same as warming. Energy is going in, but it is being used to pull particles apart rather than to raise their average speed, so the temperature does not move.
Follow with a question that catches most classes: leave the beaker at room temperature for an hour, what happens. Many answer that it becomes water at 0 degrees. It becomes water and then keeps warming towards room temperature, because the slope returns after the plateau.

Students do: sketch the temperature-time curve and mark the plateau.
Students say: where the energy goes during the plateau.

Scene 2: Particles in three states

Replace prose with three diagrams. Solid: particles packed in an ordered lattice, vibrating in place. Liquid: still close together but able to slide, so there is a fixed volume and no fixed shape. Gas: far apart, moving fast, filling the container.
Three measurable differences follow: shape, volume and compressibility. A solid fixes two of them, a liquid one, a gas none, and a gas compresses because the gaps are large.
Separate state from substance too. Steam is water in the gas state, not a new material, and dry ice is solid carbon dioxide which turns straight into gas, a change called sublimation that skips the liquid stage.

Students do: draw water, ice and steam particle diagrams, one difference each.
Students say: why a gas compresses easily and a liquid hardly at all.

Scene 3: Melting and boiling points identify a pure substance

A pure substance melts and boils at fixed temperatures: ice at 0, pure water at 100 at standard pressure. A mixture spreads and shifts the values, which is why salt water boils above 100 and never quite behaves like pure water in a pan.
Establish the idea of a fixed value by repetition: measure the same ice three times, get 0 three times, and the repeatable number is a property, not an error.
Then use pressure: at altitude the air pressure is lower, water boils in the low nineties and rice stays hard, which is exactly why a pressure cooker raises the pressure to push the boiling point above 100.

Students do: decide whether melting points of 0, -39 and 78 degrees belong to water, mercury or ethanol.
Students say: why cooking rice fails on a mountain.

Scene 4: Two equations and a sixfold gap

Warming uses E equals mass times specific heat times temperature change, changing state uses E equals mass times latent heat. These never mix.
First warm 0.5 kg of water from 20 to 100: 0.5 times 4200 times 80 is 168000 J, or 168 kJ. On a 1 kW heater that is 168 seconds, under three minutes.
Then melt 0.5 kg of ice at 334 kJ per kilogram, giving 167 kJ and 167 seconds. The two numbers are almost identical, so students conclude melting is quick, which is exactly when you introduce vaporisation: 0.5 times 2260 is 1130 kJ, and the same heater now needs 1130 seconds, about nineteen minutes.
Line the three up and state the conclusion: melting and warming sit in the same range, vaporising costs more than six times as much, which is why sweating cools you so effectively and why distillation takes so long.

Students do: work out the energy for 0.25 kg of ice and the time on a 500 W heater.
Students say: why distilling seawater takes far longer than melting ice.

04 Question types and worked steps

Type Example Steps Answer
Warming energy 0.5 kg of water from 20 to 100 E equals mass times specific heat times temperature change 168 kJ
Melting energy 0.5 kg of ice at 0, fully melted E equals mass times latent heat of fusion 167 kJ
Vaporising energy 0.5 kg of water at 100, fully vaporised E equals mass times latent heat of vaporisation 1130 kJ
Reading a curve A flat section on a temperature-time graph A change of state absorbs energy without a temperature rise The section is melting or boiling
Sanity check (teach this): Sanity checks: vaporising must cost far more than warming, and a smaller figure means the wrong equation was used; fusion at 334 kJ per kilogram against vaporisation at 2260 is a ratio near 1 to 6.8, so any answer far from that scale needs rechecking; heating 0.5 kg of water by 80 degrees in three minutes is plausible, while 50 kg would need 168000 seconds, about 46 hours, which shows a unit slip immediately; ice at 917 kg per cubic metre is less dense than water, so ice floats, and an answer with ice sinking has the densities inverted; melting and boiling points repeat exactly for a pure sample, and scatter means an impure sample or an uncalibrated probe.

05 Independent practice (3 questions)

Question Answer What to watch
Melting energy 0.25 kg of ice fully melted Check 83.5 kJ
Time 0.25 kg of ice melted on a 500 W heater Check 167 seconds
Warming energy 0.2 kg of water from 25 to 75 Check 42 kJ

06 Common mistakes and what to say

Mistake Student writes Say this
Assuming heating always raises the temperature Heat goes in, temperature goes up, so the flat bit means a broken thermometer During a change of state the energy pulls particles apart, so the temperature holds; the thermometer is fine.
Treating the two latent heats as one number Melting and boiling both use the same latent heat They differ by more than six times: 334 against 2260 kJ per kilogram for water.
Using specific heat for a change of state Melting ice with mass times 4200 times zero There is no temperature change during melting, so the specific heat equation gives zero; use latent heat.
Thinking ice is heavier than water Ice cubes sink to the bottom Ice is 917 against water at 1000, so it floats, and water expands by about nine per cent on freezing.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
The plateau on a curve A change of state is absorbing energy, so temperature holds Answering broken thermometer means the idea is missing
The two latent heats 334 for melting and 2260 for boiling, roughly seven times apart Writing one number for both means mixed equations
Choosing an equation Specific heat for warming, latent heat for a change of state Using specific heat for melting is a misapplied formula

09 Tutor FAQ

No heater or thermometer

A salt-ice bath plus a phone temperature app or a data logger shows the same plateau; the observation matters, not the equipment.

Students have not met specific heat

Build proportionality first, twice the water needs twice the time for the same rise, then give 4200 and the equation follows.

Must they memorise latent heats

Only two purposes, 334 for melting and 2260 for boiling, in kJ per kilogram; exams usually supply the value, so choosing the right equation is the skill.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →