S3 Chemistry | Preparing, collecting and testing gases – tutor prep guide (for tutors) | oxygen, hydrogen and carbon dioxide
- 2026-11-21
Two things sink students in gas practicals: they choose the wrong collection method, and they treat any bubble as proof of oxygen. This lesson splits the topic into three tables – how each gas is made, how it is collected, and how it is identified – then uses molar volume to turn mass into volume.
01 Prerequisites (3-minute check)
If any of these fails, fix it before the lesson starts.
| Skill | Quick check | Pass mark |
|---|---|---|
| Moles and molar mass | How many moles are in 5.0 g of calcium carbonate (M = 100)? | 0.05 mol |
| Molar volume | What volume does 0.05 mol of gas occupy at room conditions? | 1.2 dm3 (times 24) |
| Formulae | Name the two reactants when carbon dioxide tests with limewater | CO2 and Ca(OH)2 |
02 Lesson flow (60 minutes)
| Time | Stage | Tutor does | Student does |
|---|---|---|---|
| 0-5 min | Opening check | Ask how a jar of oxygen is obtained in the lab | Say decomposition or catalyst |
| 5-20 min | Scene 1: three preparations | Write the three equations side by side with conditions | Copy the equations with labels |
| 20-35 min | Scene 2: collection | Decide collection from a density and solubility table | Choose one method per gas and explain |
| 35-45 min | Scene 3: tests and drying | Demonstrate the three tests and the drying agent choice | Record test results and conclusions |
| 45-55 min | Independent practice | Read the questions only | Answer three questions with units |
| 55-60 min | Exit check | Read four questions and collect answers | Write each answer |
03 Teaching script (read it out)
Scene 1: Three tables: preparation, collection, test
Students keep one page with four boxes – reactants, conditions, equation, test – and open it at every practical.
Scene 2: Collection follows density and solubility
Every collection answer needs two reasons, one for density and one for solubility; the method name alone earns nothing.
Scene 3: From mass to volume, then purity and drying
Yield answers must show the theoretical value first and the actual value second, so the marking steps are visible.
04 Question types and worked steps
| Type | Example | Steps | Answer |
|---|---|---|---|
| Writing a preparation | Equation and condition for laboratory oxygen | Reactants, balance, then label the catalyst | 2H2O2 gives 2H2O + O2 with MnO2 |
| Choosing collection | Why is carbon dioxide collected upward? | Compare 44 with air at 29, then solubility | Heavier than air, slightly soluble so not over water |
| Testing a gas | How do you confirm a colourless gas is hydrogen? | Lighted splint, name the observation | A pop is heard, so it is hydrogen |
| Mass to volume | What volume of CO2 comes from 5.0 g of CaCO3? | Moles, then times 24 | 0.05 mol gives 1.2 dm3 |
05 Independent practice (3 questions)
| Question | Answer | What to watch |
|---|---|---|
| 6.5 g of zinc (M = 65) reacts with excess acid. What volume of hydrogen forms? | 0.1 mol, so 2.4 dm3 | Did they divide by molar mass before times 24? |
| 0.05 mol of CO2 is bubbled through limewater. Give the equation and observation. | Ca(OH)2 + CO2 gives CaCO3 + H2O; milky | Is the precipitate CaCO3 named? |
| Why is dilute sulphuric acid unsuitable for making carbon dioxide? | Calcium sulphate is slightly soluble and coats the marble | Is the word slightly soluble or coating present? |
06 Common mistakes and what to say
| Mistake | Student writes | Say this |
|---|---|---|
| Treating bubbles as proof of oxygen | Bubbles mean it is oxygen | Bubbles only show a gas is produced; only a relit splint shows oxygen. |
| Using dilute sulphuric acid with marble | Any acid plus any carbonate works | Calcium sulphate coats the marble and stops the reaction, so use dilute hydrochloric acid. |
| Collecting carbon dioxide over water | Over water is purest, so use it for everything | Carbon dioxide dissolves slightly, so the volume reads low; collect it upward. |
| Skipping molar volume | 5 g means 5 dm3 | Convert grams to moles first, then multiply by 24 dm3 per mole. |
07 Homework (paper, section and question numbers)
- Practice paper 1, question 2: gas preparation equations — Balance all three equations and label conditions
- Practice paper 1, question 6: collection choices — Give a density reason and a solubility reason for each
- Practice paper 1, question 10: mass to gas volume — Show moles, molar volume and yield in three steps
08 Exit check (last 5 minutes)
| Question | Answer | Decision |
|---|---|---|
| Which two substances make oxygen in the lab? | Hydrogen peroxide and manganese dioxide as catalyst | Water needs electrolysis, which is different |
| What is the molar mass of carbon dioxide, and is it heavier than air? | 44, heavier than air at 29 | Compare 44 with 29 if stuck |
| How is carbon dioxide tested? | Bubble through limewater, it turns milky | Colourless alone is not a test |
| What volume does 0.1 mol of gas occupy at room conditions? | 2.4 dm3 | An answer of 0.1 missed the times 24 |
09 Tutor FAQ
There is no manganese dioxide in the school lab. What can replace it?
Potato pieces or yeast supply catalase and give the same fast bubbling; the definition of a catalyst does not change.
What safety points matter in gas practicals?
Test hydrogen for purity before lighting it, keep jars away from flames, and work in a ventilated area.
Find a tutor — freeTutor Registration →
A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.



