/en-tutor-prep-s3-chemistry-metals-reactivity-extraction/
/en-tutor-prep-s3-chemistry-metals-reactivity-extraction/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Junior Secondary Chemistry (S3) | Metals: reactivity and extraction prep guide (for tutors) | Reactivity series, rusting and the blast furnace

Junior Secondary Chemistry (S3) | Metals: reactivity and extraction prep guide (for tutors) | Reactivity series, rusting and the blast furnace

  • 2026-11-21

Students can recite the reactivity series yet freeze when asked why zinc protects iron and copper does not. This lesson splits metals into three lines: how fast they react with water and acid, which two conditions rust needs, and how much energy it takes to free a metal from its ore.

Objectives — Students can: (1) order the series K, Na, Ca, Mg, Al, Zn, Fe, Pb, (H), Cu, Ag, Au and use it to predict reactions with water and dilute acid, explaining that copper sits below hydrogen and so does not react with dilute hydrochloric acid; (2) write Zn + 2HCl -> ZnCl2 + H2 and calculate that 6.54 g of zinc (0.1 mol) gives 0.1 mol of hydrogen, which is 2.4 dm3 at 24 dm3/mol; (3) state that rusting needs both oxygen and water, and explain three prevention methods (coating, galvanising by sacrificial protection, alloying into stainless steel); (4) use Fe2O3 + 3CO -> 2Fe + 3CO2 to get 112 g of iron from 160 g of iron oxide, that is 70%, and 560 kg of iron from 1,000 kg of ore containing 80% iron oxide.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Symbols and formulae How is iron oxide written? Fe2O3, two iron and three oxygen
Moles and molar mass What volume does 1 mol of hydrogen occupy at room conditions? About 24 dm3
Balancing equations How do you balance Zn + HCl? Zn + 2HCl -> ZnCl2 + H2, hydrogen and chlorine must match

02 Lesson flow (60 minutes)

Time Stage Tutor does Student does
0-5 min Opening question Hold up an iron nail, a copper strip and a magnesium ribbon and ask which reacts with acid Vote and give one reason
5-20 min Act 1: the reactivity series Order potassium to gold, show K, Na, Ca with water and Mg, Al, Zn, Fe with dilute acid, mark copper below hydrogen Predict three reactions from the series and write the observations
20-35 min Act 2: corrosion and prevention Set up three nails (dry, water, salt water), name the two conditions, then coating, galvanising and stainless steel Explain the principle behind each of three methods
35-45 min Act 3: extraction and calculation Three blast furnace steps, then 160 g iron oxide giving 112 g iron and 1,000 kg ore giving 560 kg Calculate the hydrogen from 6.54 g of zinc
45-53 min Independent practice Circulate, stepping in only when a mole ratio is inverted Finish three questions showing each mole ratio
53-60 min Exit check Mark the three questions on the spot; two or more wrong means reteaching Act 3 Self-assess and note which act to review

03 Teaching script (read it out)

Scene 1: The series answers three questions at once

Order the metals from most to least reactive: K, Na, Ca, Mg, Al, Zn, Fe, Pb, (H), Cu, Ag, Au. That one line answers three questions: does it react with water, does it react with dilute acid, and is it found native or as a compound. Potassium, sodium and calcium react with cold water, magnesium needs hot water or steam, zinc and iron only bubble with dilute acid, and copper, silver and gold ignore dilute hydrochloric acid, which is why copper and gold occur native.

Run a contrast: a magnesium ribbon and an iron nail in separate tubes of 2 mol/dm3 hydrochloric acid. Magnesium fizzes at once and warms up, iron produces slow fine bubbles. Students must record the rate difference, not “reacts or not”, because both react. Then ask why zinc can coat iron: zinc is more reactive, so it corrodes first, which is sacrificial protection.

Reactive metals sit on the left; a more reactive coat sacrifices itself.

Scene 2: Rust needs two conditions at once

Iron rusts only when oxygen and water are both present. Set up three nails: one sealed with desiccant, one in distilled water, one in salt water, and compare after a week. The dry nail barely changes, the water nail shows red-brown patches, and the salt water nail goes fastest because ions make the water more conducting and speed up electrochemical corrosion. Students should name the two conditions rather than saying “air makes it rust”.

Each prevention method removes one condition. Paint or grease blocks oxygen and water. Galvanising wraps the iron in a more reactive metal so zinc corrodes first even when the coat is scratched. Stainless steel adds chromium and nickel, forming a dense chromium oxide layer. Rust is Fe2O3.xH2O, chemically different from iron, so rusting is a chemical change, not a colour change.

Rust equals oxygen plus water; prevention blocks a condition or adds a sacrificial metal.

Scene 3: From ore to metal: energy and mole ratios

The more reactive the metal, the harder it is to reduce. Potassium, sodium and calcium need electrolysis of molten salts, aluminium needs electrolysis of molten alumina with cryolite to lower the melting point, zinc, iron and lead can be reduced by carbon or carbon monoxide, copper can be heated with carbon, and gold and silver need nothing at all. The blast furnace has three steps: coke burns to supply heat and make carbon monoxide, carbon monoxide reduces the ore by Fe2O3 + 3CO -> 2Fe + 3CO2, and limestone removes silica impurities.

Then work the calculation to the end: the molar mass of Fe2O3 is 56 times 2 plus 16 times 3, which is 160, and the equation shows 1 mol of iron oxide giving 2 mol of iron, that is 112 g. So 160 g of ore yields 112 g of iron, a mass percentage of 112 over 160, which is 70%. Scale up: 1,000 kg of ore at 80% iron oxide holds 800 kg of Fe2O3, and 800 times 0.7 gives 560 kg of iron. Insist on units at every step, because mixing mole ratios with masses is the most common loss of marks.

More reactive means harder to reduce; 1 mol Fe2O3 gives 2 mol Fe, that is 112 g.

04 Question types and worked steps

Type Example Steps Answer
Predict a reaction What happens when a copper strip sits in dilute hydrochloric acid? Locate copper in the series against hydrogen Below hydrogen, so no reaction and no bubbles
Equation and gas volume How much hydrogen comes from 6.54 g of zinc with excess acid? Mole ratio 1:1, then multiply by 24 dm3/mol 0.1 mol of hydrogen, that is 2.4 dm3
Prevention principle Why are zinc blocks bolted to a ship hull? Compare reactivity of zinc and iron to see which corrodes first Zinc is more reactive and is oxidised first, protecting the iron
Mass percentage How much iron from 1,000 kg of ore containing 80% iron oxide? Find the pure oxide at 800 kg, then take 70% 560 kg of iron
Sanity check (teach this): Sanity check: the mass of iron must be less than the mass of ore, so 560 kg from 1,000 kg is reasonable and 1,120 kg means the mole ratio was inverted. A mass percentage must be under 100%: iron is 70% of iron oxide and oxygen is the other 30%, and 112 plus 48 makes 160, which is a free self-check. Gas volume must scale with moles, so 0.1 mol of hydrogen is 2.4 dm3 and 24 dm3 would mean 1 mol. Predictions must match the series: a student writing that copper reacts violently with dilute acid has the series backwards.

05 Independent practice (3 questions)

Question Answer What to watch
24 g of magnesium reacts completely with excess acid. How many moles and how many dm3 of hydrogen? 1 mol of hydrogen, 24 dm3 Check the working divides 24 by 24 to get 1 mol
Why does an iron nail in a sealed dry jar stay shiny for a week? No water, so one of the two conditions is missing Check both oxygen and water are named
Aluminium is more reactive than iron, so why do aluminium windows outlast iron ones? A dense oxide layer forms and blocks further corrosion Check the oxide layer is described as protective

06 Common mistakes and what to say

Mistake Student writes Say this
Learning the series backwards Answering that copper reacts violently with dilute acid The left end is the most reactive, and copper sits to the right of hydrogen, which means it is less reactive than hydrogen, so dilute acid cannot touch it. Read it left to right and answer again.
Mixing mole ratios with masses Writing 160 g of iron oxide gives 2 g of iron The numbers in front of the formulae are mole ratios: 1 mol of iron oxide gives 2 mol of iron. Convert grams to moles, apply the ratio, then convert back to grams. Three steps, none of them skippable.
Assuming air alone causes rust Saying “it rusts outside” Oxygen and water are both needed. The sealed nail with desiccant sat for a week without rusting because water was missing. Look at the results before answering.
Explaining prevention as “a coat of something” Saying paint stops rust without a reason Paint blocks oxygen and water. Galvanising works differently: zinc is more reactive, so it sacrifices itself even when scratched. Say which principle you mean.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
Does copper react with dilute hydrochloric acid, and why? No, copper sits to the right of hydrogen in the series If wrong, reteach the series in Act 1
Which two conditions does rusting need? Oxygen and water together If wrong, reteach the three nails in Act 2
How much iron comes from 160 g of iron oxide? 112 g, that is 70% If wrong, reteach the mole ratio in Act 3

09 Tutor FAQ

Should students memorise the whole series?

Memorise the stretch from zinc through iron, lead, hydrogen to copper, plus the fact that potassium, sodium and calcium react with cold water. Everything else can be reasoned from position.

Must the three blast furnace steps be memorised?

They must be explained, not recited. Coke supplies heat and makes carbon monoxide, carbon monoxide reduces the ore, limestone removes impurities, and each step answers a separate question.

Is there a practice paper to go with this?

Yes. The homework section links the matching paper and the chapter index, split into reactivity and calculation, with question numbers as printed.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →