/en-tutor-prep-s3-chemistry-salt-preparation-solubility-practice-3/
/en-tutor-prep-s3-chemistry-salt-preparation-solubility-practice-3/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Paper 3: precipitation, yield and composition

Paper 3: precipitation, yield and composition

  • 2026-11-21

Paper 3: precipitation, yield and composition

Chapter practice with ten items, answers and a one-line note for each, about 25 minutes.

Paper 3 Ten items on this chapter with answers for immediate marking.

01 Paper details (check answers afterwards)

Item Detail
Questions 10
Suggested time 25
Difficulty mix Foundation 4 · Intermediate 2 · Challenge 2 · Error redo 2
Chapter Chapter: Salt preparation and solubility
Level Challenge

02 Questions (10 items)

  1. FoundationMixing 50 cm3 of 0.2 mol/dm3 silver nitrate with 50 cm3 of 0.2 mol/dm3 sodium chloride gives how much silver chloride?
  2. FoundationA precipitate has a theoretical yield of 2.87 g and 2.44 g is obtained. What is the percentage yield?
  3. FoundationHow much copper oxide reacts completely with 0.05 mol of dilute sulphuric acid?
  4. FoundationIf 5.0 g of copper oxide is added, how much solid is left after the reaction?
  5. IntermediateHow much anhydrous copper sulphate is in 12.5 g of the hydrated crystals?
  6. IntermediateA salt has solubility 60 g at 40 C. If 150 g is added to 200 g of water, how much stays undissolved?
  7. ChallengeSolubility is 110 g at 60 C and 25 g at 20 C. How much crystallises from a saturated solution in 300 g of water cooled to 20 C?
  8. ChallengeA saturated solution with solubility 25 g has what percentage by mass?
  9. Error redoWhy wash precipitate crystals with a little cold water?
  10. Error redoWhy not heat a solution to dryness to recover a hydrated salt?

03 Answers and one-line notes

# Answer One-line note
1 1.435 g There is 0.01 mol of silver ions and the molar mass of silver chloride is 143.5.
2 85.0% 2.44 divided by 2.87 then times 100 gives 85.0.
3 3.98 g The molar ratio is 1 to 1 and the molar mass of copper oxide is 79.5.
4 1.03 g 5.0 minus 3.975 gives 1.025, rounded to two decimal places.
5 8.0 g The hydrated salt has molar mass 250 and the anhydrous salt 160, a ratio of 0.64.
6 30 g 200 g of water dissolves at most 120 g, leaving 30 g undissolved.
7 255 g Each 100 g of water gives 85 g of crystals, so three times that is 255 g.
8 20% 25 divided by 125 then times 100.
9 To remove soluble impurities sticking to the surface. Cold water keeps the loss from re-dissolving small.
10 Strong heating drives off the water of crystallisation and may decompose the salt. Evaporate to saturation and then cool to crystallise.

04 What to do after marking

  • After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
  • Repeat the same item two days later; move to the next paper only when both attempts are correct.
  • Parents only need the answer and note columns; there is no need to explain every item.

Decide first how the gas is collected and tested; do the 24 dm3 conversion last.Tutor Registration →

Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →