S3 Physics Heat and Energy Transfer Practice 4 (Retry)
- 2026-11-21
S3 Physics Heat and Energy Transfer Practice 4 (Retry)
Ten items target the usual slips: heat versus temperature, taking ΔT, grams versus kilograms, inverted efficiency, kWh against joules and latent heat.
The ten commonest traps Name the mistake first, then write the correct method rather than memorising answers.
01 Paper details (check answers afterwards)
| Item | Detail |
|---|---|
| Questions | 10 |
| Suggested time | 25 |
| Difficulty mix | Foundation 4 · Intermediate 2 · Challenge 2 · Error redo 2 |
| Chapter | Chapter: S3 Physics: heat and energy transfer |
| Level | Retry |
02 Questions (10 items)
- FoundationA student says “this water is very hot, so it has a lot of heat”. What is wrong?
- FoundationWater is heated from 30 °C to 70 °C. What goes wrong if a student uses ΔT = 70 + 30, and what is the correct value?
- FoundationHow much energy raises 500 g of water by 20 °C? A common error is substituting 500 directly.
- FoundationStudents often invert the efficiency formula. What is the correct form?
- IntermediateHow many joules are in 1 kWh, and why is electricity billed in kWh rather than J?
- IntermediateA student claims convection happens inside a heated solid. Is that right?
- ChallengeSome students think a vacuum stops all heat loss. Which mode of transfer does that ignore?
- ChallengeIf the mass of water is doubled but the temperature rise is the same, how does the energy needed change?
- Error redoIce at 0 °C keeps absorbing heat while melting yet its temperature stays the same. Why?
- Error redoWhat is the unit of power, and how does it differ from the unit of energy?
03 Answers and one-line notes
| # | Answer | One-line note |
|---|---|---|
| 1 | The statement confuses temperature with heat. A body does not contain heat; heat is energy in transit, measured in J. | Temperature is a state quantity, heat is a process quantity. |
| 2 | ΔT must be final minus initial = 40 °C; using 100 overstates the energy by a factor of 2.5. | ΔT is always final minus initial, never a sum. |
| 3 | 42000 J; convert the mass to 0.5 kg first, otherwise the answer is 1000 times too big. | The mass in Q = mcΔT must be in kg. |
| 4 | Efficiency = useful output energy ÷ total input energy × 100 %, never more than 100 %. | Inverting it gives an impossible value above 100 %. |
| 5 | 1 kWh = 3.6 × 10⁶ J; households use large amounts, so kWh keeps the numbers small and the meter easy to read. | kWh is a unit of energy, not of power. |
| 6 | No. Convection needs bulk movement of particles, so it only occurs in liquids and gases; solids conduct only. | Particles in a solid are fixed in place, so no convection current can form. |
| 7 | It ignores radiation: a vacuum blocks conduction and convection, but heat still crosses as electromagnetic waves. | A vacuum is not perfect insulation. |
| 8 | It doubles (252000 J), because Q is proportional to mass. | In Q = mcΔT, Q is proportional to m. |
| 9 | The energy breaks down the crystal structure (latent heat of fusion) instead of raising temperature, so it stays at 0 °C. | During a change of state the energy alters the arrangement, not the temperature. |
| 10 | Power is measured in watts (W), that is J/s, while energy is in joules (J); a higher-power heater boils the same water faster. | W = J/s, so power is the rate of energy transfer. |
04 What to do after marking
- After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
- Repeat the same item two days later; move to the next paper only when both attempts are correct.
- Parents only need the answer and note columns; there is no need to explain every item.
Download the full ten-item paper as a PDF, answers and notes included.Tutor Registration →
Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.



