S4 Chemistry | Hard Water and Water Treatment: A Tutor’s Planning Guide | From ppm to resin capacity in one calculation
- 2026-11-17
Students happily recite that hard water contains more minerals but freeze when asked to convert. Hardness is the concentration of calcium and magnesium ions expressed as calcium carbonate equivalent, so 40 mg/L of calcium becomes 100 mg/L and 12 mg/L of magnesium becomes 50, giving 150 in total, which is hard water. Boiling removes only the hydrogencarbonate part; a resin cartridge is sized by moles of capacity divided by molar concentration.
01 Prerequisites (3-minute check)
If any of these fails, fix it before the lesson starts.
| Skill | Quick check | Pass mark |
|---|---|---|
| Moles and concentration | Moles of solute in 500 litres of 0.002 mol/L solution | 500 x 0.002 = 1.0 mol |
| Relative formula mass | Relative formula mass of calcium carbonate and of calcium | 100 and 40 respectively |
| Precipitation | What happens when limewater is added to hard water | Calcium carbonate precipitate forms |
| Practical skill | How soap solution is used to compare hardness | Equal volumes of water and soap; compare lather and scum |
02 Lesson flow (60 minutes)
| Time | Stage | Tutor does | Student does |
|---|---|---|---|
| 0-8 min | Three opening questions | What makes water hard, is Hong Kong tap water hard, does boiling remove hardness | Oral answers; teacher builds three columns: ions, equivalent, treatment |
| 8-22 min | Act one: hardness is a concentration | 40 mg/L calcium x 100/40 = 100 mg/L as calcium carbonate; 12 mg/L magnesium x 100/24 = 50; total 150 is hard; boundaries at 60, 120 and 180 | Students complete both conversions and report the total |
| 22-40 min | Act two: boiling solves only half the problem | Calcium hydrogencarbonate decomposes to calcium carbonate, water and carbon dioxide; magnesium hydrogencarbonate decomposes then hydrolyses; sulfates and chlorides survive boiling as permanent hardness; lime softening and washing soda | Students write the equation and name the hardness that survives |
| 40-52 min | Act three: resin capacity and alternatives | Sodium-form resin exchanges sodium for calcium and magnesium; 1.0 mol capacity against 500 litres at 0.002 mol/L is exactly saturated; distillation and reverse osmosis remove all ions and give the lowest conductivity; cost and volume trade-offs | Students calculate the saturation volume and describe regeneration |
| 52-58 min | Quick tests and what they answer | Soap lather shows hardness, conductivity shows total dissolved ions, pH paper shows acidity; match each method to its question | Students pair method with question |
| 58-60 min | Exit check | Three questions collected and marked; errors tagged to conversion, mechanism or capacity | Independent work |
03 Teaching script (read it out)
Scene 1: Act one: convert to the same unit before comparing
Complete both conversions and report the total hardness value.
Scene 2: Act two: boiling drives off only the part that precipitates
Write the boiling equation and name the hardness that is unaffected.
Scene 3: Act three: how many litres will one cartridge treat
Calculate the saturation volume and describe one regeneration method.
04 Question types and worked steps
| Type | Example | Steps | Answer |
|---|---|---|---|
| Conversion | Convert 20 mg/L magnesium to calcium carbonate equivalent | Write the factor 100/24, multiply, then state the unit | 20 x 100/24 = 83 mg/L |
| Equation | Write the thermal decomposition of calcium hydrogencarbonate | Reactants, products, state symbols and balancing | Ca(HCO3)2 -> CaCO3 + H2O + CO2 |
| Capacity | Capacity 2.0 mol, water at 0.005 mol/L calcium, how many litres | Capacity divided by concentration with sensible significant figures | 2.0 / 0.005 = 400 litres |
| Comparison | Distillation or ion exchange for a household | Compare cost, volume and maintenance before judging | Distillation is pure but energy hungry; resin needs regeneration |
05 Independent practice (3 questions)
| Question | Answer | What to watch |
|---|---|---|
| Two-step conversion | Calcium 30 mg/L and magnesium 6 mg/L: find total hardness and classify | 30 x 2.5 + 6 x 4.17 = 100, moderately hard |
| Equation balancing | Write the two steps for heating magnesium hydrogencarbonate | Carbonate plus water and carbon dioxide, then hydroxide |
| Capacity | Capacity 1.5 mol, concentration 0.003 mol/L: find the saturation volume | 500 litres |
| Method comparison | Three lines comparing distillation, reverse osmosis and ion exchange | One dimension per line: range removed, cost, maintenance |
06 Common mistakes and what to say
| Mistake | Student writes | Say this |
|---|---|---|
| Ranking hardness by milligrams | 40 mg/L of calcium is harder than 40 mg/L of magnesium because calcium matters more. | At equal concentration magnesium has the higher equivalent, since 100/24 exceeds 100/40. Convert to calcium carbonate equivalent before comparing; comparing mg/L directly is wrong. |
| Believing boiling softens completely | Boil hard water for ten minutes and hardness becomes zero. | Boiling decomposes hydrogencarbonates and removes temporary hardness only; calcium sulfate and calcium chloride are unaffected. Scale proves precipitation, not the absence of hardness. |
| Misusing resin capacity units | Capacity 1.0 mol with water at 0.002 mol/L means 0.002 litres can be treated. | Divide capacity by concentration: 1.0 / 0.002 = 500 litres. Check units before multiplying or dividing and always state litres. |
| Calling ion exchange destruction | After the resin, the calcium in the water has been destroyed. | The resin swaps calcium for sodium; the calcium ends up in regeneration waste and must be treated. Say transferred, not destroyed. |
07 Homework (paper, section and question numbers)
- Secondary Chemistry chapter index — Revise the moles and concentration chapters before retrying this page
- Acids and alkalis chapter — Separate neutralisation from precipitation first
08 Exit check (last 5 minutes)
| Question | Answer | Decision |
|---|---|---|
| Equivalent of 40 mg/L calcium | 100 mg/L | Reteach the 100/40 factor |
| Hardness removed by boiling | Temporary hardness only | Return to the act two equation |
| Saturation volume of the resin | 500 litres | Redo capacity divided by concentration |
09 Tutor FAQ
Must students memorise 60, 120 and 180?
Yes, because classification answers need numbers; without them soft, hard and very hard cannot be justified.
Why does the soap test work?
Calcium and magnesium form scum with soap, so low lather and heavy scum indicate higher hardness.
Should drinking distilled water be discussed?
No. This chapter is about water quality indicators; health advice is outside the syllabus.
Find a tutor — freeTutor Registration →
A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.



