Secondary Maths (DSE) | Teaching Guide: Straight Lines and Slope | Two numbers describe a whole line
- 2026-11-22
Students can recite y = mx + c and still stop dead when handed two points, because slope was never shown to them as something you can count.
01 Prerequisites (3-minute check)
If any of these fails, fix it before the lesson starts.
| Skill | Quick check | Pass mark |
|---|---|---|
| Substitution | Put x = 3 into y = 2x – 3, what is y? | y = 3 |
| Solving a linear equation | In 3x + 4y = 12, what is x when y = 0? | x = 4 |
| Negative division | What is -1 divided by 2? | -0.5 |
02 Lesson flow (60 minutes)
| Time | Stage | Tutor does | Student does |
|---|---|---|---|
| 0-5 min | Prior check | Ask substitution, intercepts, negative division | Two of three correct before starting |
| 5-15 min | Meaning of slope | Plot (2,1) to (6,9) on squared paper and count | Students count up 8 right 4, slope 2 |
| 15-22 min | From slope to equation | Point slope form y – y1 = m(x – x1) | Students write y = 2x – 3 |
| 22-30 min | Parallel and perpendicular | Same slope is parallel, product -1 is perpendicular | Students get perpendicular slope -0.5 |
| 30-40 min | Reading general form | The three numbers in 3x + 4y = 12 | Students name slope -0.75 and intercepts 4 and 3 |
| 40-52 min | Bisector and intersection | Midpoint (4,5) plus perpendicular slope; equate the two lines | Students get y = -0.5x + 7 and (3,3) |
| 52-60 min | Exit check | Ask what the slope of a vertical line is | They say undefined, not zero |
03 Teaching script (read it out)
Scene 1: Draw first, write later
Do not open with the formula. Plot (2, 1) and (6, 9) on squared paper and let students count with a pencil: how many squares up, how many across. They get up 8, right 4, and only then write 8 divided by 4 equals 2.
What this builds is that slope means how far you rise per one square across, not a rule to memorise. Then write point slope form: y – 1 = 2(x – 2), which expands to y = 2x – 3. Ask them to substitute x = 6 and confirm y = 9 returns the original point. That is the moment the equation and the picture become the same object.
Ask the student: slope 2 means for one square across, how many squares up?
Scene 2: Parallel reads the slope, perpendicular reads the product
Parallel lines are easy for students; perpendicular lines usually come down to a chant about flipping and negating. Give them something they can check instead: the slopes of perpendicular lines multiply to -1.
Show 2 times -0.5 equals -1. Then ask about a slope of -1: the negative reciprocal is 1, and the product is again -1. Then ask about a horizontal line and a vertical line: one has slope 0, the other has no slope at all, so the product rule never fires, yet the two lines are obviously perpendicular. That question is what makes the rule a rule rather than a definition, and vertical lines need their own case.
Ask the student: why is the slope of the vertical line x = 5 not zero?
Scene 3: Pull all three numbers out of general form
Students can read every symbol in 3x + 4y = 12 and still not name the slope. Teach two moves: isolate y to get y = -0.75x + 3, so slope and y intercept appear at once; then put y = 0 to get the x intercept 4.
Only then give a parallel and a perpendicular through a point: through (1, 2) the parallel is 3x + 4y = 11 and the perpendicular is 4x – 3y = -2. Make students substitute (1, 2) back into both. Run that check three times in the lesson, because the most common loss in Paper 1 is finishing the equation and never substituting back.
Ask the student: why is the perpendicular through (1,2) the line 4x – 3y = -2 rather than -2y?
04 Question types and worked steps
| Type | Example | Steps | Answer |
|---|---|---|---|
| Two points | (2, 1) and (6, 9) | Slope 8 over 4 is 2, then point slope form | y = 2x – 3 |
| Parallel line | Through (3, 1) parallel to y = 2x – 3 | Same slope 2, substitute the point for the intercept | y = 2x – 5 |
| Perpendicular line | Through (2, 1) perpendicular to slope 2 | Slope -0.5, substitute the point | y = -0.5x + 2 |
| General form | 3x + 4y = 12 | Isolate y for the slope, put 0 for intercepts | Slope -0.75, intercepts 4 and 3 |
05 Independent practice (3 questions)
| Question | Answer | What to watch |
|---|---|---|
| Two points | Find the line through (2, 1) and (6, 9) | y = 2x – 3, both points must fit |
| Perpendicular bisector | Bisector of (2, 1) and (6, 9) | Midpoint (4, 5), slope -0.5, y = -0.5x + 7 |
| Intersection | Where do y = 2x – 3 and y = -x + 6 meet? | (3, 3), true in both equations |
06 Common mistakes and what to say
| Mistake | Student writes | Say this |
|---|---|---|
| Sign slip in point slope form | y – 1 = 2(x + 2) | You wrote x + 2 but the point has x = 2, so it must be x – 2. Treating the minus as a negative slides the whole line 4 squares the wrong way. |
| Perpendicular written as a positive reciprocal | Slope 2 has perpendicular slope 1 over 2 | Perpendicular flips and negates: minus 1 over 2, that is -0.5. A positive 0.5 is just a flatter line going the same way. |
| Swapping the intercepts | In 3x + 4y = 12 the x intercept is 3 | The x intercept needs y = 0, giving x = 4; putting x = 0 gives the y intercept 3. The 3 you named is the y intercept, so the two numbers are swapped. |
| Calling a vertical line zero slope | The slope of x = 5 is 0 | Slope 0 is the horizontal line y = 5. The line x = 5 rises forever without going across, so its slope is undefined, not zero. |
07 Homework (paper, section and question numbers)
- Maths index — All chapters in this subject
- Related: quadratic word problems — Do questions 1 to 3 of the practice set
- Related: variation — Do questions 4 to 6 of the practice set
08 Exit check (last 5 minutes)
| Question | Answer | Decision |
|---|---|---|
| Meaning of slope | Rise per one square across | Reciting a formula means redrawing once |
| Perpendicular test | Slopes multiply to -1 | Missing it means two more items |
| Vertical slope | Say undefined | Saying zero means drawing it again |
09 Tutor FAQ
Why does a vertical line have no slope
Slope is rise divided by run, and a vertical line has zero run, so the division is undefined; the value is neither zero nor infinity.
Why do perpendicular slopes multiply to -1
Treat the two lines as direction vectors whose components are the run and the rise; perpendicular means their dot product is zero, which simplifies to the product of slopes plus one being zero.
Why not use the two point formula directly
The two point formula works but still needs the slope, and point slope form is the shape that is easiest to check with a substitution on exam paper.
Find a tutor — freeTutor Registration →
A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.



