S4 Physics | Energy, power and efficiency – tutor prep guide (for tutors) | work, power and efficiency with conservation checks
- 2026-11-20
Students can recite W = Fs, but ask who finished the same job faster and the answer is only push harder. This lesson separates three quantities: joules of work done, watts done per second, and how much of that was actually useful.
01 Prerequisites (3-minute check)
If any of these fails, fix it before the lesson starts.
| Skill | Quick check | Pass mark |
|---|---|---|
| Squares and roots | What is the square root of 2 x 10 x 5? | 10 m/s |
| Unit conversion | How many joules is 0.3 kWh? | 1.08 x 10 to the 6 J |
| Percentages | 180 out of 240 as a percentage | 75% |
02 Lesson flow (60 minutes)
| Time | Stage | Tutor does | Student does |
|---|---|---|---|
| 0-5 min | Opening check | Ask what changes when a bag goes upstairs slowly or quickly | Say faster, but cannot quantify |
| 5-20 min | Scene 1: work and three energies | Write three formulas side by side, ask where energy comes from and goes | Write an energy chain |
| 20-35 min | Scene 2: power | Work 1200 J in 4 s, then compare two stair climbs | Compute and compare both |
| 35-45 min | Scene 3: efficiency | Motor and lamp examples, name the loss each time | State the form of the lost energy |
| 45-55 min | Independent practice | Read the questions only | Answer three questions with units |
| 55-60 min | Exit check | Read three questions and collect answers | Write each answer and unit |
03 Teaching script (read it out)
Scene 1: One formula per question type
Require an energy chain for every answer, for example potential to kinetic to heat and sound.
Scene 2: Power: same job, different time
Keep W and W apart: one is the joule of work, the other is the watt. Units must follow the quantity.
Scene 3: Efficiency: useful over total, and name the loss
Efficiency is always below 100%. A result like 120% means input and output were swapped.
04 Question types and worked steps
| Type | Example | Steps | Answer |
|---|---|---|---|
| Work | 400 N pushes through 3 m: how much work? | W = Fs, same direction | 1200 J |
| Potential and kinetic | 2 kg raised 5 m: GPE? | GPE = mgh | 100 J |
| Power comparison | Same 1800 J in 6 s and in 12 s | P = W/t for each | 300 W and 150 W |
| Efficiency | Input 240 W, output 180 W | Useful over total x 100% | 75%, 60 W lost as heat |
05 Independent practice (3 questions)
| Question | Answer | What to watch |
|---|---|---|
| A hoist lifts a load 4 m at a steady 500 N. How much work? | 2000 J | Whether displacement is multiplied in |
| A 2 kg object falls from 5 m. Speed on landing? | 10 m/s from half m v squared = 100 | Whether GPE is converted to KE first |
| Input 400 J, useful 300 J: efficiency and loss? | 75%, loss 100 J | Whether the percentage is multiplied by 100 |
06 Common mistakes and what to say
| Mistake | Student writes | Say this |
|---|---|---|
| Treating power as force | I used 300 W of force | W is the watt, a joule per second; force is in newtons. They never swap. |
| Efficiency as input over output | 500 / 300 = 167% | Efficiency is always useful over total, so it stays below 100%. |
| Forgetting g or using the wrong g | 2 kg x 5 = 10 J | GPE always needs g; this course uses 10 N/kg, so state the value you use. |
| Mixing kWh with joules | 0.3 kWh = 0.3 J | 1 kWh is 3.6 x 10 to the 6 J, so 0.3 kWh is 1.08 x 10 to the 6 J. |
07 Homework (paper, section and question numbers)
- Practice paper 1, question 2: work and GPE — Both parts need an energy chain
- Practice paper 1, question 5: comparing power — Same job, two people: compute both and compare
- Practice paper 1, question 9: efficiency — Percentage plus where the loss goes, units included
08 Exit check (last 5 minutes)
| Question | Answer | Decision |
|---|---|---|
| 2 kg raised 5 m: GPE? | 100 J | 10 J means g was missed |
| 1800 J done in 12 s: power? | 150 W | 21600 means multiplication |
| Input 500 W, useful 300 W: efficiency? | 60%, with 200 W as heat | 167% means swapped terms |
| 0.3 kWh in joules? | 1.08 x 10 to the 6 J | Write the conversion at home if unknown |
09 Tutor FAQ
Is g = 9.81 marked wrong?
DSE commonly uses 10 N/kg. A 9.81 answer within tolerance is accepted, but one question must not mix both values.
Must students name the form of the loss?
Yes. Heat and sound scores better than a bare percentage, and long questions usually award a mark for the loss.
Find a tutor — freeTutor Registration →
A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.



