/en-tutor-prep-s5-ict-iot-embedded-systems-practice-2/
/en-tutor-prep-s5-ict-iot-embedded-systems-practice-2/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

S5 ICT IoT and Embedded Systems Practice 2 (Advanced)

S5 ICT IoT and Embedded Systems Practice 2 (Advanced)

  • 2026-11-18

S5 ICT IoT and Embedded Systems Practice 2 (Advanced)

Ten items cover multi-device data volume, the sampling theorem, bandwidth, edge versus cloud latency, protocol overhead, LoRa range and multi-year battery life.

Bandwidth, latency and battery life estimates List device count, rate and units, multiply or divide, then sanity-check the magnitude.

01 Paper details (check answers afterwards)

Item Detail
Questions 10
Suggested time 25
Difficulty mix Foundation 4 · Intermediate 2 · Challenge 2 · Error redo 2
Chapter Chapter: S5 ICT: IoT and embedded systems
Level Advanced

02 Questions (10 items)

  1. Foundation1,000 devices each upload one 40-byte reading per minute. What is the daily volume in MB?
  2. FoundationA sensor signal contains frequencies up to 50 Hz. What is the minimum sampling rate by the sampling theorem?
  3. Foundation1,000 devices each send 200 bytes every 60 seconds. What bandwidth is needed in kbps?
  4. FoundationCloud processing takes 180 ms round trip; edge processing at the gateway takes 15 ms. By what percentage does latency fall?
  5. IntermediateEach message carries a 32-byte payload plus a 2-byte MQTT fixed header. What share of the total traffic is protocol overhead?
  6. IntermediateLoRa reaches about 5 km line of sight in open country while WiFi reaches about 100 m. How many times further is LoRa?
  7. ChallengeA 500 mAh battery powers a node that idles at 10 uA and transmits four times a day for 2 seconds at 20 mA. How many years will it last?
  8. ChallengeHow many seconds does 1 MB take over an 8 Mbit/s link in theory?
  9. Error redoError check: 1 MB was treated as 1 Mb when estimating transfer time. By what factor is the answer too small?
  10. Error redoError check: in MQTT, what is the central component that receives and forwards messages called?

03 Answers and one-line notes

# Answer One-line note
1 54.93 MB (57,600,000 bytes). 1,000 devices times 1,440 minutes gives 1.44 million readings, then times 40 bytes.
2 100 Hz. The rate must be at least twice the highest frequency, or aliasing appears.
3 About 26.7 kbps. Turn bytes into bits by multiplying by 8, then divide by 60 seconds.
4 It falls by 91.7 percent. Subtract 15 from 180 to get 165, then divide by 180.
5 About 5.9 percent. The total is 34 bytes, of which 2 bytes are overhead.
6 50 times. LoRa trades data rate for range, which suits scattered sensor nodes.
7 About 1,758 days, or 4.8 years. Idling costs 0.24 mAh and transmitting about 0.044 mAh, roughly 0.284 mAh a day.
8 1 second (1 MB equals 8 Mb). Capital B means bytes and lower-case b means bits, a factor of 8 apart.
9 Eight times too small. Settle bytes against bits first, or every timing estimate comes out short.
10 The broker. Publishers and subscribers never meet; everything passes through the broker.

04 What to do after marking

  • After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
  • Repeat the same item two days later; move to the next paper only when both attempts are correct.
  • Parents only need the answer and note columns; there is no need to explain every item.

Download the full ten-item paper as a PDF, answers and notes included.Tutor Registration →

Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →