/en-tutor-prep-s6-physics-measurement-uncertainty-graph-analysis/
/en-tutor-prep-s6-physics-measurement-uncertainty-graph-analysis/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Secondary Physics | Measurement Uncertainty and Graph Analysis Lesson-Prep Guide (for tutors) | Error propagation, significant figures, gradient and intercept

Secondary Physics | Measurement Uncertainty and Graph Analysis Lesson-Prep Guide (for tutors) | Error propagation, significant figures, gradient and intercept

  • 2026-11-20

Students write 9.87 as an exact answer and report a 25.0 millimetre reading as 25.035; asked what a gradient means they say it goes up. This lesson turns raw readings into answers that can be defended, using three propagation rules and one reading of a straight line.

Objectives — Students can: 1) state the uncertainty of a reading from the instrument scale and report a result with the correct number of significant figures; 2) propagate uncertainty with the three rules, absolute for addition, percentage for multiplication and index times for powers; 3) read a gradient and intercept as physical quantities with units, and estimate uncertainty from steepest and shallowest lines; 4) separate systematic from random error and describe how each appears on a graph and how each is reduced.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Decimals and standard form Write 0.00042 in standard form 4.2 times ten to the minus four
Percentages Express 0.5 against 25.0 as a percentage 2 per cent
Straight-line equation In y equals mx plus c, what are m and c called Gradient and intercept

02 Lesson flow (45 minutes)

Time Stage Tutor does Student does
0-6 min Reading warm-up Measure a length with a millimetre ruler and write the reading with its uncertainty Write 25.0 plus or minus 0.5 millimetres and explain the half division
6-14 min Significant figures Show that addition follows decimal places while multiplication follows significant figures Do 2.0 times 3.14159 and 25.0 plus 0.005
14-26 min Propagation Show the three rules: add absolutes, add percentages, multiply by the index Get the uncertainty in g from T and L
26-34 min Gradient Show that gradient units are the y unit over the x unit and that the intercept is an offset Find the spring constant from a force against extension graph, with units
34-42 min Systematic and random Show a zero error shifting the whole line and random scatter spreading the points Label two graphs and state the remedy for each
42-45 min Exit check Collect three answers and note whether the error is a rule, a unit or a reading Work independently

03 Teaching script (read it out)

Scene 1: Read to half a division and quote one digit of uncertainty

A millimetre ruler read at 25.0 millimetres carries half a division, 0.5 millimetres; measuring a difference between two marks needs both readings, so 0.5 and 0.5 add to 1 millimetre. That is why one length costs twice the uncertainty of one position, and it is where students who always write plus or minus 0.5 go wrong.
Results follow a convention: the uncertainty keeps one significant figure and the value is written to the same decimal place, so 25.0 plus or minus 0.5 millimetres is right while 25.035 plus or minus 0.5 is false precision. Percentage uncertainty is the uncertainty over the value times one hundred: 0.5 over 25.0 is 2 per cent.
Students do: measure a pencil once and write the reading, the uncertainty and the percentage.
Students say: why the uncertainty keeps only one digit.

Students repeat: read to half a division, quote one digit of uncertainty, and align the decimal places.

Scene 2: Three propagation rules: classify before computing

Ask first whether the formula adds or multiplies. Addition adds absolute uncertainties, so 25.0 plus or minus 0.5 with 10.0 plus or minus 0.5 gives 35.0 plus or minus 1.0. Multiplication adds percentages, so 1 per cent from L and 5 per cent from T combine into 6 per cent.
Powers multiply by the index: g equals four pi squared times L over T squared, so the 5 per cent in T becomes 10 per cent and joins the 1 per cent from L to give 11 per cent. With g equal to 9.87 the uncertainty is 0.11 times 9.87, about 1.1, and the answer reads 9.9 plus or minus 1.1. The most common slip is to forget the doubling, which halves the reported uncertainty.
Students do: take d as 2.00 plus or minus 0.02 centimetres and find the sphere volume with its uncertainty.
Students say: why a squared term doubles its percentage.

Students repeat: addition adds absolutes, multiplication adds percentages, powers multiply by the index.

Scene 3: Gradient units are the axis units divided, and the intercept is an offset

Once the points lie on a line, the gradient is not how much it rises but the y unit divided by the x unit: force against extension gives newtons per metre, which is the spring constant, and voltage against current gives volts per ampere, which is the resistance. Writing the unit down is how a student knows what was measured.The intercept carries meaning too. A non-zero intercept on a force against extension graph usually means the spring was already under tension or the ruler had a zero error; on a voltage against current graph it may be a meter offset. Systematic error shifts or tilts the whole line and averaging readings will not remove it, so the instrument is calibrated; random error scatters points about the line and repeated readings averaged do reduce it.
Students do: draw a best-fit line through six points and state gradient, intercept and both units.
Students say: three reasons an intercept might not be zero.

Students repeat: gradient units are the two axes divided, the intercept is an offset, systematic error needs calibration and random error needs averaging.

04 Question types and worked steps

Type Example Steps Answer
Uncertainty of a reading A reading of 25.0 millimetres on a millimetre ruler: uncertainty and percentage Half a division, 0.5 millimetres, and 0.5 over 25.0 is 2 per cent Plus or minus 0.5 millimetres, 2 per cent
Error propagation T is 2.00 plus or minus 0.10 seconds and L is 1.00 plus or minus 0.01 metres: find g and its uncertainty g comes to 9.87; 1 per cent plus twice 5 per cent gives 11 per cent, about 1.1 9.9 plus or minus 1.1 metres per second squared
Significant figures How many figures should 2.0 times 3.14159 carry Follow the value with the fewest significant figures, which is two 6.3
Graph reading A force against extension graph has gradient 12 and intercept 0.4: give the spring constant and the zero offset Gradient is the spring constant, 12 newtons per metre, and the intercept is a pre-tension of 0.4 newtons 12 N/m and 0.4 N
Sanity check (teach this): An uncertainty must be far smaller than the value, so a plus or minus 25 on a value of 25 means the formula was misapplied; a percentage cannot shrink during propagation, so a total smaller than any single contribution means the terms were not added; the gradient unit must match the target quantity, so a spring constant in metres per newton means the axes were swapped; an intercept as large as the range points at a zero error rather than a straight line drawn through noise.

05 Independent practice (3 questions)

Question Answer What to watch
Take d as 2.00 plus or minus 0.02 centimetres and find the sphere volume with its uncertainty Volume 4.19 cubic centimetres, 3 per cent giving plus or minus 0.13, so 4.19 plus or minus 0.13 Whether the 1 per cent was multiplied by three
Find R from V equals IR with V at 6.0 plus or minus 0.2 volts and I at 0.50 plus or minus 0.01 amperes R is 12 ohms; 3.3 per cent plus 2 per cent gives 5.3 per cent, about 0.6 12 plus or minus 1 ohm with one digit of uncertainty
A graph has a clearly non-zero intercept: give two causes and the remedy A zero error or a pre-tension; calibrate the instrument or subtract the zero reading Whether systematic error was described as random

06 Common mistakes and what to say

Mistake Student writes Say this
Quoting too many digits Writing: 25.035 plus or minus 0.5 millimetres The uncertainty has one digit and the value must match its decimal place, so 25.0 plus or minus 0.5.
Forgetting the index in propagation Writing: T has 5 per cent error, so g has 5 per cent error T is squared in the formula, so 5 per cent becomes 10 per cent, and with the 1 per cent from L the total is 11 per cent.
Leaving the gradient unitless Writing: the gradient is 12, so the spring constant is 12 The gradient carries newtons per metre, and without the unit there is no way to know what was measured.
Treating a zero error as random Writing: averaging more readings will remove the zero error A zero error shifts the whole line, so averaging does not help; the instrument is calibrated or the offset subtracted.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
Uncertainty of a reading on a millimetre ruler Plus or minus 0.5 millimetres, and plus or minus 1 millimetre for a difference Quoting 1 millimetre for a single reading means reteaching act one
T carries 5 per cent: how much does g gain The squared term doubles it, so 10 per cent from T Answering 5 per cent means reteaching act two
What the gradient of force against extension means, with its unit The spring constant in newtons per metre A bare number means reteaching act three

09 Tutor FAQ

Which year group is this for

S6 students preparing for school practical assessment and DSE paper one; S4 and S5 students writing lab reports benefit too.

Is 45 minutes enough

Yes, because the lesson only covers readings, propagation and graph reading; the full report becomes homework.

Are there practice papers

Yes, the homework block links to the site chapters on Hooke law, circuits and circular motion, all original with answers.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →