IGCSE Chemistry | Metal Extraction and the Reactivity Series (for tutors) | Electrolysis, carbon reduction, blast furnace
- 2026-11-16
Students write electrolysis for every metal because it is taught first, but only the top five need it. One ordered list pins all three methods down, then students do the mass sum themselves.
01 Prerequisites (3-minute check)
If any of these fails, fix it before the lesson starts.
| Skill | Quick check | Pass mark |
|---|---|---|
| Formulae | how iron oxide and carbon monoxide are written | write Fe2O3 and CO |
| Balancing | atoms equal on both sides | balance Fe2O3 + CO within 30 seconds |
| Molar mass | the mass of one mole of Fe2O3 | get 160 from 2×56 + 3×16 |
| Ions and electrons | metal cations gain electrons at the cathode | state Al3+ + 3e- gives Al |
02 Lesson flow (60 minutes)
| Time | Stage | Tutor does | Student does |
|---|---|---|---|
| 0–8 min | Opening diagnosis | ask why iron and copper occur naturally but aluminium never does | write an answer, revisit at the end |
| 8–20 min | Build the series | order K to Au and ask which occur native | students write the series and mark carbon and hydrogen |
| 20–34 min | Match methods | sort the ten metals into three columns | students give one example per column with a reason |
| 34–50 min | Blast furnace and the mass sum | write three equations, then 160 to 112 tonnes | students compute 70 percent and 80 percent yield |
| 50–58 min | Aluminium electrolysis | cryolite, cathode product, 14.5 kWh per kg | students say why iron is not electrolysed |
| 58–60 min | Exit check | collect two questions, mark at once | students restate the wrong step |
03 Teaching script (read it out)
Scene 1: The series is one inference, not a table to chant
Ask one student to restate the rule in their own words before moving on.
Scene 2: Blast furnace: three equations and two supporting roles
Ask one student to restate the rule in their own words before moving on.
Scene 3: Aluminium electrolysis: why cryolite, why so expensive
Ask one student to restate the rule in their own words before moving on.
04 Question types and worked steps
| Type | Example | Steps | Answer |
|---|---|---|---|
| Choose the method | pick a method for a named metal | locate it in the series, match the column, one reason | the carbon sentence must appear |
| Furnace equations | write the three reactions inside the furnace | burn, make CO, reduce the ore | three equations or lose marks |
| Mass and yield | iron from 160 tonnes of ore | use the 112 to 160 ratio, apply yield, give units | never treat ore tonnes as iron tonnes |
| Explain the electrolysis | why cryolite, why energy heavy | lower the melting point, cathode product, anode wear | separate the energy point from the cost point |
05 Independent practice (3 questions)
| Question | Answer | What to watch |
|---|---|---|
| Three columns | sort Zn, Mg, Cu and Na into the methods | look for the carbon sentence |
| Furnace equations | write the three stages | look for CO2 + C gives 2CO |
| Yield sum | 160 tonnes of ore at 80 percent | look for 89.6 tonnes with units |
06 Common mistakes and what to say
| Mistake | Student writes | Say this |
|---|---|---|
| Electrolysis for everything | writing that iron is extracted by electrolysis | Iron sits below carbon, so carbon takes its oxygen and the blast furnace is used. Electrolysis is for potassium, sodium, calcium, magnesium and aluminium. |
| Limestone as reducing agent | writing that limestone reduces iron oxide | Limestone reacts with silica to form slag and removes impurities. Carbon monoxide is the reducing agent; keep the two apart. |
| Missing the middle step | writing Fe2O3 + C gives Fe + CO2 only | There is a step in between, CO2 + C gives 2CO, which makes the carbon monoxide. Three equations, not one. |
| Mass direction reversed | writing that 112 tonnes of ore give 160 tonnes of iron | Iron is only 70 percent of the ore, so the output must be smaller than the input. An answer larger than the ore means the ratio was flipped. |
07 Homework (paper, section and question numbers)
- IGCSE Chemistry chapter index — all chapters for this subject
- Prep guide master index — similar chapters in other subjects
- Redo this chapter — practice questions 1 to 3: three columns, furnace equations, 80 percent yield
08 Exit check (last 5 minutes)
| Question | Answer | Decision |
|---|---|---|
| One position | carbon sits between aluminium and zinc | wrong means back to the series |
| Three equations | burn, make CO, reduce the ore | a missing one means rewrite them |
| One number | 160 tonnes give 112 tonnes, that is 70 percent | wrong means redo the ratio |
09 Tutor FAQ
Do students memorise the whole series?
Yes, but only the ten main metals plus carbon and hydrogen; most questions only ask whether a metal sits above or below carbon.
Is blast furnace iron pure?
No. It is cast iron with a high carbon content and it is brittle; steelmaking lowers the carbon first.
Why can copper be called native?
Copper sits below hydrogen, so it barely combines with oxygen, and native copper exists; industrially most copper still comes from sulfide ore by roasting.
Find a tutor — freeTutor Registration →
A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.



