/en-tutor-prep-igcse-chemistry-organic-cracking-polymers/
/en-tutor-prep-igcse-chemistry-organic-cracking-polymers/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

IGCSE Chemistry | Organic Chemistry: Cracking and Polymers Teaching Guide (for tutors) | Fractional distillation, alkanes, alkenes, addition polymerisation

IGCSE Chemistry | Organic Chemistry: Cracking and Polymers Teaching Guide (for tutors) | Fractional distillation, alkanes, alkenes, addition polymerisation

  • 2026-11-16

Students can recite CnH2n+2 yet write a cracking equation that loses carbon atoms, and they assume polyethene weighs more than ethene. This lesson pins every answer with atom counting and conservation of mass.

Objectives — Students can: (1) name the eight fractions from top to bottom of the column and explain distillation with bigger molecules having higher boiling points and being more viscous and harder to burn; (2) write CnH2n+2 for alkanes and CnH2n for alkenes, identify an alkene with bromine water going from orange to colourless, and balance C2H4 plus 3O2 giving 2CO2 plus 2H2O; (3) balance the cracking equation C10H22 giving C8H18 plus C2H4 by counting atoms and state why industry cracks; (4) write addition polymerisation of ethene and show that 2.8 g of ethene, which is 0.1 mol with Mr 28, still gives 2.8 g of polyethene; (5) give three routes for polymer waste with their costs.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Symbols and formulae the symbols for carbon and hydrogen write C and H and count atoms
Relative molecular mass Mr is the sum of atomic masses C2H4 has Mr 28
The mole mass divided by Mr gives moles 2.8 g of ethene is 0.1 mol
Combustion products of complete combustion carbon dioxide and water

02 Lesson flow (60 minutes)

Time Stage Tutor does Student does
0–8 min Opening diagnosis ask why crude oil is distilled rather than burned as it is write an answer, revisit at the end
8–22 min Eight fractions order them top to bottom with one use each students order the list themselves
22–34 min Alkanes and alkenes two formulae and the bromine water test students state the colour change
34–50 min Cracking and polymerisation count atoms for C10H22, then work the 2.8 g case students balance and convert to moles
50–57 min Three waste routes recycling, biodegradable plastic, incineration, each with a cost one example each
57–60 min Exit check three quick oral questions students restate the failed step

03 Teaching script (read it out)

Scene 1: Fractional distillation: cut by boiling point first, then name the fractions

Crude oil is a mixture whose molecules differ in chain length, so they differ in boiling point, and that is the whole principle. The column is hottest at the bottom and coolest at the top: long chains with high boiling points stay low, short chains rise and condense near the top. Top to bottom the eight fractions are refinery gas, gasoline, naphtha, kerosene, diesel, fuel oil, lubricating oil and bitumen. Drill the pattern until it is instinct: bigger molecules boil higher, are more viscous, darker, harder to burn and smoke more. Close with the commercial reason: demand is highest for short chains such as gasoline but crude oil holds more long chains, so industry cracks the long ones.
Ask students to: order the eight fractions and write one everyday use beside each, such as kerosene for jet fuel.

Ask one student to restate the rule in their own words before moving on.

Scene 2: Alkanes and alkenes: two formulae and one test cover every question

Alkanes are saturated with single bonds only, formula CnH2n+2, such as propane C3H8, fairly unreactive and used mainly as fuels. Alkenes contain a carbon to carbon double bond, formula CnH2n, such as ethene C2H4, are more reactive and undergo addition reactions. The distinguishing test has one standard answer: bubble the gas through bromine water, an alkene turns the orange solution colourless, an alkane leaves it orange. Balancing matters: C2H4 plus 3O2 gives 2CO2 plus 2H2O, with carbon 2 to 2, hydrogen 4 to 4 and oxygen 6 to 6. Alkenes burning in limited air also give soot, which is a separate point from alkanes.
Ask students to: write both formulae and the bromine result on one line and start every answer from that line.

Ask one student to restate the rule in their own words before moving on.

Scene 3: Cracking and addition polymerisation: atom counting and conservation of mass

Cracking breaks long alkanes into shorter alkanes plus alkenes at around 600 to 700 degrees with a catalyst. The standard example, C10H22 giving C8H18 plus C2H4, balances by counting: ten carbons left against eight plus two, twenty-two hydrogens against eighteen plus four, so nothing needs memorising. The purpose is always converting low demand long chains into high demand short chains and alkenes. Addition polymerisation opens the double bond so n ethene molecules, each Mr 28, join into one long chain with the repeat unit CH2CH2. The key sentence is conservation of mass: 2.8 g of ethene is 0.1 mol, and the polyethene formed is still 2.8 g, only now the molecules are a few enormous chains; at 5,000 repeat units per chain the chain Mr is 28 times 5,000, which is 140,000. Finish with waste: polyethene is not broken down by microbes, so recycling costs sorting and energy, biodegradable plastic needs specific conditions, and incineration releases carbon dioxide.

Ask one student to restate the rule in their own words before moving on.

04 Question types and worked steps

Type Example Steps Answer
Fraction position question explain where a fraction is collected boiling point, chain length, temperature gradient boiling point must be linked to chain length
Alkane or alkene question distinguish two gases with one test bromine water orange to colourless means alkene flammability is not a valid test
Cracking equation question balance the cracking of C10H22 count carbon, count hydrogen, write both products atoms must balance on both sides
Polymer calculation question from monomer mass to polymer mass and chain size conservation of mass, repeat unit Mr, multiply by n polymer mass equals monomer mass
Sanity check (teach this): Sanity checks: every lesson keeps the order distillation, then alkanes and alkenes, then cracking and polymerisation; each answer passes three checks, atoms balance on both sides (C10H22 is ten carbons and twenty-two hydrogens), mass is unchanged by polymerisation (2.8 g in, 2.8 g out), and the alkene test is bromine water turning colourless rather than burning; any claim that polyethene is heavier is rewritten as the same mass in far fewer, far longer molecules; any claim that distillation is a chemical reaction is rewritten as physical separation with no new substance.

05 Independent practice (3 questions)

Question Answer What to watch
Order the fractions top to bottom with one use each look for short chains to long chains
Balance cracking C10H22 gives C8H18 plus what look for C2H4 and balanced atoms
Polymer mass how much polyethene from 2.8 g of ethene look for 2.8 g and conservation of mass

06 Common mistakes and what to say

Mistake Student writes Say this
Carbon lost from the cracking equation writing C10H22 gives C8H18 plus CH4 Do not guess, count: ten carbons and twenty-two hydrogens on the left, C8H18 takes eight carbons and eighteen hydrogens, so two carbons and four hydrogens remain, which is C2H4.
Assuming the polymer is heavier writing that polyethene has a greater mass because Mr is larger A larger Mr means one bigger chain, not more mass. 2.8 g of ethene gives 2.8 g of polyethene and not a single atom is added.
Calling distillation a reaction writing that distillation breaks crude oil into new substances Distillation only separates by boiling point. The fractions already exist in the crude oil and the column simply collects them at different heights.
Using flammability to identify an alkene writing that a gas must be an alkene because it burns Alkanes burn as well. The only reliable test is bromine water: colourless means alkene, unchanged orange means alkane.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
One principle distillation separates by boiling point, not a reaction wrong: back to act one
One test bromine water orange to colourless means alkene confused: repeat act two
One conservation 2.8 g in, 2.8 g out; Mr is only chain size wrong: back to act three

09 Tutor FAQ

Must the catalyst be named in cracking?

Copy any conditions the question gives, and when only products are asked a balanced equation with one alkane and one alkene is enough.

Is the repeat unit C2H4 or CH2CH2?

Both are accepted, because after the double bond opens each carbon still carries two hydrogens.

Why learn the order of fractions?

Questions often ask where a fraction is collected, and the order is the reverse of boiling point: shorter chains collect nearer the top.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →