/en-tutor-prep-igcse-chemistry-rates-of-reaction/
/en-tutor-prep-igcse-chemistry-rates-of-reaction/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

IGCSE Chemistry | Rates of Reaction Teaching Guide (for tutors) | Collision theory, measurements, gradients

IGCSE Chemistry | Rates of Reaction Teaching Guide (for tutors) | Collision theory, measurements, gradients

  • 2026-11-16

Students can recite that heating speeds a reaction up, but asked why, they only say particles move faster and never separate collision frequency from activation energy. Given a graph they measure from start to finish and call it the initial rate. Marks sit in three places: explaining with collision theory rather than describing, choosing the right measuring method, and reading the gradient at the start of the curve.

Objectives — Students can: (1) explain concentration, temperature, surface area and catalysts with collision theory (the first three change collision frequency; a catalyst lowers activation energy); (2) calculate a mean rate with the right unit (2.4 g lost in 60 s is 0.04 g/s; 48 cm³ collected in 24 s is 2.0 cm³/s); (3) point to the steepest part of a mass-time or volume-time graph and explain that the curve flattens because reactant concentration falls.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Particle model Matter is made of particles says particles are always moving
Equations and reactions Reactants become products says particles must collide to react
Gradient and units Rate is change per unit time distinguishes g/s from cm³/s

02 Lesson flow (60 minutes)

Time Stage Tutor does Student does
0–8 min Opening probe Ask why powdered calcium carbonate reacts faster than lumps Write the answer, revisit at the end
8–22 min Collision theory and four factors Concentration, temperature, area change frequency; catalyst lowers activation energy Sorts the four factors
22–34 min Three measuring methods Gas volume, mass loss, turbidity or colour Picks a method for one reaction
34–46 min Calculating mean rate 2.4 g / 60 s = 0.04 g/s Calculates two rates
46–56 min Graphs: initial gradient and why they flatten Steepest at the start; flattening means falling concentration Marks the initial gradient
56–60 min Exit check Collect two questions, mark at once, name the slip Works independently

03 Teaching script (read it out)

Scene 1: Collision theory is two questions: how often, and hard enough

Open with one line: a reaction needs collisions, and those collisions need enough energy to pass the activation energy. Concentration, pressure and surface area change how often particles collide. Temperature changes both. A catalyst only lowers the activation energy, so more collisions become effective. Correct the common line that a catalyst makes particles collide more: the collision count is unchanged, the effective collisions rise. A catalyst also does not move the position of equilibrium, it only gets there sooner.

Ask one student to separate heating from adding a catalyst and say why both raise the rate for different reasons.

Scene 2: Measurement first: ask what changes that you can observe

Three standard methods. Collect gas in a syringe or gas jar, unit cm³/s (48 cm³ / 24 s = 2.0 cm³/s). Loss in mass on a balance, unit g/s (2.4 g / 60 s = 0.04 g/s). Or time until a cross disappears, or colour depth, giving seconds or s⁻¹. A full answer says what is measured, with what apparatus, and in what unit. For the cross method, a shorter time means a faster reaction, so the direction must not be flipped.

Ask one student why a shorter cross-disappearance time means a higher rate.

Scene 3: Graphs: steepest at the start, gradient is the rate, flattening is not stopping

Mass-time and volume-time graphs read the same way: the curve is steepest at the beginning because concentration is highest. Take the gradient of a tangent, or the mean over the seconds the question names, never start-to-finish, which only gives an average rate. A flat curve has two causes: reactants used up, or concentration so low the change is unmeasurable. Say falling concentration reduces collision frequency. The plateau equals the theoretical yield and is a quick answer check.

Ask one student to mark the steepest section on the graph and explain why it is not the last section.

04 Question types and worked steps

Type Example Steps Answer
Collision theory explanation Explain why a factor speeds a reaction Name collision frequency or activation energy, then link to effective collisions A catalyst never increases collisions
Rate calculation Find rate from mass or volume and time Change divided by time, unit written A missing unit loses the mark
Graph analysis Compare two curves for speed and yield Gradient compares speed, plateau compares yield Keep speed and yield separate
Experiment design Design a fair comparison Change one variable, hold temperature, concentration, volume fixed State how it is measured
Sanity check (teach this): Sanity checks: the chapter always runs collision theory, then measurement, then graphs. Every answer passes three checks: rate units are always change over time, a catalyst changes only activation energy and never the collision count or equilibrium position, and a 10 °C rise roughly doubles the rate, so 20 °C roughly quadruples it. Replace any claim that a catalyst increases collisions with the activation energy explanation, and a fair test changes exactly one variable.

05 Independent practice (3 questions)

Question Answer What to watch
Rate calculation 2.4 g lost in 60 s, find the mean rate Check the unit is g/s and the time divides
Graph analysis Two volume-time curves, one steeper but with a lower plateau Check speed and yield are discussed separately
Collision theory Explain why a powder reacts faster Check surface area and exposed particles are mentioned

06 Common mistakes and what to say

Mistake Student writes Say this
Saying a catalyst increases collisions Writes that a catalyst makes particles collide more The count of collisions is unchanged. A catalyst opens a route with lower activation energy, so more collisions are effective.
Using the overall average as the initial rate Takes the gradient from start to finish Start to finish is an average. The initial rate is the tangent at the beginning, where concentration is highest.
Claiming a flat curve means the reaction stopped Writes that the reaction is over because the curve is flat It may be finished, or so slow that nothing measurable changes. Compare with the theoretical yield before saying it stopped.
Leaving the rate without a unit Writes rate = 2.4 / 60 = 0.04 0.04 of what? Write 0.04 g/s. Without a unit the answer is incomplete.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
Two ideas Collision frequency and activation energy Cannot separate them: return to script one
One unit Change divided by time No unit: return to script two
One sentence Steepest at the start; flattening means falling concentration Cannot say it: return to script three

09 Tutor FAQ

Does a catalyst increase the yield?

No. It only reaches equilibrium sooner and does not shift its position, so the final yield is unchanged.

Why does a 10 °C rise roughly double the rate?

The energy distribution shifts right so a larger fraction of particles passes the activation energy, and collisions are also more frequent. IGCSE needs only these two directions.

Does the mass loss method work for every reaction?

Only where a gas escapes, such as a carbonate with acid. In a sealed vessel or where gas is collected, use volume or turbidity instead.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →