/en-tutor-prep-s1-physics-density-floating-sinking/
/en-tutor-prep-s1-physics-density-floating-sinking/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Junior Secondary Physics (S1) | Teaching Guide: Density, Floating and Sinking | One piece of iron, two outcomes

Junior Secondary Physics (S1) | Teaching Guide: Density, Floating and Sinking | One piece of iron, two outcomes

  • 2026-11-22

A nail sinks and a ship floats, and students explain it with size. Size is not the cause: what changes is the displaced volume. This lesson settles density, displacement and net force with numbers instead of feelings.

Objectives — Students can: (1) compute density as mass over volume with the right unit, 270 g in 100 cm3 giving 2.7 g/cm3; (2) judge floating against water at 1.0 g/cm3, wood at 0.8 floating and stone at 2.5 sinking; (3) compute net force from displacement, 300 cm3 giving 3.0 N of buoyancy against a weight of 2.4 N, a net 0.6 N upwards, and state that 80 percent is submerged and 20 percent above water.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Mass and weight Which one is unchanged on the Moon Mass stays the same, weight changes
Reading a measuring cylinder How do you read the level Eye level with the bottom of the meniscus
Balanced forces What happens when two equal forces oppose Zero resultant, so rest or steady speed

02 Lesson flow (60 minutes)

Time Stage Tutor does Student does
0-5 min Prior knowledge check Mass against weight, cylinder reading, balanced forces Two correct answers before measuring
5-18 min Measure before calculating Mass and displaced volume of the aluminium block, giving 2.7 Unit and decimal place both right
18-30 min Water as the benchmark Predict, then drop wood and stone Students contrast 0.8 with 2.5
30-42 min Submerged fraction Measure how much of the wood sits under water Around 80 percent submerged
42-52 min Net force Fully immerse 300 cm3 and read the force meter Net force comes out at 0.6 N
52-58 min Independent practice Four questions on density, floating, fraction and net force Every answer shows working and units
58-60 min Exit check Ask why the same iron floats as a box Larger displacement, lower average density

03 Teaching script (read it out)

Scene 1: Measure first, never assume heavy sinks

Students start from weight, so a big stone and a small needle both sinking seems consistent, until a steel ship breaks the rule. The first move builds a computable quantity: density is mass divided by volume in g/cm3, with water at 1.0.

The aluminium block gives 270 g over 100 cm3, so 2.7; the wood gives 240 g over 300 cm3, so 0.8. Put those two numbers side by side and floating becomes a comparison, not a feeling.

Ask the student: did you decide with weight or density, and why is weight not enough?

Scene 2: Water as the benchmark, predict then test

Before anything goes in the water, the student writes float or sink with a reason, then the test runs. Wood at 0.8 floats, stone at 2.5 sinks, and the wrong prediction is where the teaching happens.

A floating body is not weightless: the wood weighs 2.4 N while fully immersed water of 300 cm3 weighs 3.0 N, so a net 0.6 N pushes it back up until it settles with 80 percent submerged and 20 percent showing. That fraction is the density ratio, which checks the answer.

Ask the student: what holds up the part of the wood above the surface?

Scene 3: Same iron, two outcomes

A nail and a steel box share one material density but behave differently, because displacement differs. Crumple a piece of foil and it sinks; fold the same piece into a boat and it floats. The student must say that mass did not change while displaced volume grew, so average density fell.

Once that is said, the size explanation disappears by itself, because size is an effect of displacement, not its cause.

Ask the student: did the mass of the foil change, and which quantity did?

04 Question types and worked steps

Type Example Steps Answer
Density 270 g in 100 cm3 of aluminium Formula, substitution, unit, in that order 2.7 g/cm3, above 1.0 so it sinks
Float or sink Wood and stone in water Compare density only, never size 0.8 floats, 2.5 sinks
Submerged fraction Measure how much of the wood is under water Fraction equals the density ratio 80 percent under, 20 percent above
Net force Fully immersed 300 cm3 weighing 2.4 N Buoyancy minus weight, state the direction 3.0 minus 2.4 gives 0.6 N upwards
Sanity check (teach this): Four checks: (1) density must carry g/cm3, and a bare gram means the volume went missing; (2) wood must land below 1.0 to float, so 0.8 is sound while 8.0 signals a decimal slip; (3) a submerged fraction must sit between 0 and 100 percent, and 80 percent matches a density of 0.8; (4) the net force must be smaller than the buoyancy itself, 0.6 N under 3.0 N, and anything larger means the weight was added the wrong way.

05 Independent practice (3 questions)

Question Answer What to watch
Density, four questions Three objects with mass and volume supplied Check formula, substitution and unit
Floating, three questions Different materials in fresh and salt water Check that only density was compared
Fraction and force, three questions Submerged fraction, net force, force meter reading Check direction and significant figures

06 Common mistakes and what to say

Mistake Student writes Say this
Judging by size It is big, so it floats Size is not the cause; give me displaced volume and average density and then we have an answer.
Dropping the density unit The density is 2.7 The unit? Without g/cm3 I do not know what you measured.
Believing a floating body has no weight If it floats it has no weight The floating wood still weighs 2.4 N; the displaced water carries it.
Confusing buoyancy with weight Buoyancy is just how heavy it is Buoyancy is the weight of water displaced, not the weight of the object; keep the two numbers apart.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
Density Compute one density on the spot with its unit A missing unit means two more questions
Floating State the single quantity that decides floating Weight means repeating the benchmark demo
The ship question Explain in one sentence why an iron ship floats Size as the answer means the model is not yet held

09 Tutor FAQ

Why is it easier to float in salt water

Salt water is denser than 1.0 g/cm3, so a body needs a smaller submerged fraction and floats more easily.

How does a submarine dive and rise

It takes in or blows out water, changing its weight while the volume stays almost fixed, so its density changes.

Why does ice float

Ice is about 0.9 g/cm3, below water, so it floats with roughly nine tenths submerged.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →