/en-tutor-prep-s1-physics-electric-circuits-current-voltage/
/en-tutor-prep-s1-physics-electric-circuits-current-voltage/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Junior Secondary Physics (S1) | Teaching Guide: Current, Voltage and Simple Circuits | Series and parallel compared

Junior Secondary Physics (S1) | Teaching Guide: Current, Voltage and Simple Circuits | Series and parallel compared

  • 2026-11-22

Students say the current gets used up, so they expect the second bulb in series to be dimmer. Two meter readings kill that idea: current is the same everywhere in a series loop, and it is voltage that gets shared.

Objectives — Students can: (1) state the two conditions for a lit bulb, a source and a closed circuit; (2) distinguish series from parallel, stating that series current is the same everywhere and parallel branch currents add, so 0.2 A plus 0.2 A gives 0.4 A; (3) find resistance from V equals IR, where 6 V and 0.3 A give 20 ohms, and check by voltage sharing with two 10 ohm resistors taking 3 V each.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Unit of current What is the unit of current The ampere (A)
Decimal division What is 6 divided by 0.3 20
Circuit symbols Which terminal does the long battery line mark The positive terminal

02 Lesson flow (60 minutes)

Time Stage Tutor does Student does
0-6 min Prior knowledge check Ask the unit of current, the battery symbol and one division Two correct answers before moving on
6-16 min When a bulb lights Show an open circuit, a broken wire and a closed loop Student names the one that lights
16-26 min Series current Two bulbs in series, measure current at three points All three readings match
26-36 min Voltage sharing Measure the voltage across each bulb 3 V plus 3 V gives 6 V
36-46 min Parallel current Two branches, measure branch and total current 0.2 A plus 0.2 A gives 0.4 A
46-56 min Resistance Use 6 V and 0.3 A to get 20 ohms Write V equals IR before substituting
56-60 min Exit check Ask why the second series bulb does not get less current Current is the same everywhere

03 Teaching script (read it out)

Scene 1: Three readings settle the used-up idea

Put two bulbs in series and measure the current after the battery, between the bulbs, and before the return terminal. All three readings must agree. When a student sees the middle reading drop, it is almost always a parallel connection or the wrong meter range, not a real current loss. Use one meter and one range for all three readings and let the student read the numbers.

One sentence is enough: charge is not consumed in a bulb, energy is. The bulb converts electrical energy into light and heat while the current stays the same around the loop.

Ask: should the three readings match or fall, and why?

Scene 2: Series shares voltage, parallel shares current

Two 10 ohm resistors in series across 6 V take 3 V each, and the two add to exactly 6 V, while the current stays 0.3 A all the way round. Parallel is the mirror image: every branch sees the full 6 V, and the current splits, 0.2 A plus 0.2 A giving 0.4 A in total.

Write both statements as facing columns on the board. When the only question asked is which quantity is being shared, students do not need a mnemonic.

Ask: in parallel, which quantity is shared?

Scene 3: One formula, but three questions before using it

V equals IR applies to a whole circuit or to a single component, never to one bulb voltage with another bulb current. Before substituting, ask whether the circuit is series or parallel, which component the unknown belongs to, and what the voltage across that component is.

With 6 V and 0.3 A the total resistance is 20 ohms, so two identical bulbs are 10 ohms each. Two 10 ohm resistors in parallel give 5 ohms, smaller than either branch, and that fact alone is a useful check on any answer.

Ask: why is a parallel resistance smaller than the smallest branch?

04 Question types and worked steps

Type Example Steps Answer
Series current Two bulbs in series, current between them Series current is the same everywhere 0.3 A
Parallel current Two branches at 0.2 A each Add the branch currents 0.4 A in total
Voltage sharing Two 10 ohm resistors across 6 V Split in proportion to resistance 3 V each
Resistance 6 V and 0.3 A V equals IR, so R is V over I 20 ohms
Sanity check (teach this): Four checks: series current measured at two points must agree; parallel branch currents must add to the total, 0.2 plus 0.2 giving 0.4; series voltages must add to the supply, 3 plus 3 giving 6; and a parallel equivalent of 5 ohms must be smaller than either 10 ohm branch, so an answer of 20 ohms means parallel was treated as series.

05 Independent practice (3 questions)

Question Answer What to watch
Series and parallel Four questions classifying circuits and computing readings Check that the type is written first
Voltage sharing Two series-bulb questions Check the sum against the supply voltage
Resistance Three questions using V equals IR Check the decimal point and the unit

06 Common mistakes and what to say

Mistake Student writes Say this
Thinking current is used up The second series bulb carries less current Series current is equal everywhere; voltage is what changes
Treating parallel as series Parallel resistance comes out larger A parallel equivalent is smaller than the smallest branch
Mixing components in V equals IR One bulb voltage with another bulb current Confirm voltage and current belong to the same component
Sliding the decimal point Writing 2 ohms for 6 divided by 0.3 Dividing by a number below one gives a bigger answer, so estimate first

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
Current conservation State the three series readings A falling answer means repeat the measurement
Sharing rule Say which quantity series shares and which parallel shares Reversed answers mean two more questions
Resistance Compute the resistance for 6 V and 0.3 A An answer of 2 ohms means practise decimal division

09 Tutor FAQ

Why does the bulb light if the current never drops

A bulb consumes electrical energy, not charge; the same amount of charge passes each point every second.

Does a battery run out of voltage

Its chemical energy runs out and the emf falls, but within a closed circuit the component voltages add up to the battery voltage.

Why are series bulbs dimmer

Each bulb receives only part of the supply voltage, so its power falls, even though the current is the same.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →