/en-tutor-prep-s1-physics-heat-conduction-convection-radiation/
/en-tutor-prep-s1-physics-heat-conduction-convection-radiation/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Junior Secondary Physics (S1) | Teaching Guide: Conduction, Convection and Radiation | One transfer, three routes

Junior Secondary Physics (S1) | Teaching Guide: Conduction, Convection and Radiation | One transfer, three routes

  • 2026-11-22

Every student can say that hot air rises, yet stops dead when asked why the Sun still warms the Earth through space. This lesson gives each of the three routes its own visible evidence, not three slogans.

Objectives — Students can: (1) read conduction direction from the order in which wax rings melt, comparing a copper rod at 5 s with a steel rod at 25 s, a factor of 5; (2) explain convection with dye moving in water, hot fluid rising and cold fluid sinking; (3) show that radiation needs no medium, with the black can rising 12 C and the shiny can 4 C in ten minutes, and map the three routes onto a thermos wall.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Temperature and heat Does the hotter object always hold more energy Not necessarily; mass and specific heat matter
Unit of energy What is the unit of heat energy The joule (J)
Particle model How are particles arranged in a solid Closely packed, vibrating in place

02 Lesson flow (60 minutes)

Time Stage Tutor does Student does
0-5 min Prior knowledge check Ask for temperature versus heat, the unit of energy and the solid particle model Two correct answers before the demo
5-18 min Wax ring race Copper and steel rods with wax at equal spacing, heated at one end Students state the order and the factor
18-30 min Dye convection Dye in hot water and in cold water, swapped positions Students name the rising and sinking paths
30-42 min Black against shiny Two cans lit from the same distance for ten minutes Students quote 12 against 4 C
42-52 min Thermos layers Match each wall layer to one route Students name what each layer blocks
52-58 min Independent practice Four questions on conduction, convection, radiation and insulation Each answer carries a reason sentence
58-60 min Exit check Ask why a vacuum blocks two routes but not the third No particles for conduction or convection, radiation still passes

03 Teaching script (read it out)

Scene 1: Run the wax rings, never trust the hand

Students judge which metal conducts faster by touching it, so the hand plays thermometer and stopwatch at once and gets both wrong. The first move is a single setup: two rods of equal length, wax at equal spacing, one end heated, and the order of melting recorded.

The copper ring at 5 s and the steel ring at 25 s differ by a factor of 5. That number is not for memorising; it builds the picture that energy passes particle to particle, with nothing travelling along the rod.

Ask the student: what does the melting order tell you about where energy goes, and does the wax itself move?

Scene 2: Convection without colour is not an experiment

Repeating that hot water rises is a slogan. Use two clear tanks: dye in hot water placed on top, dye in cold water placed below, then swap once. The dye path is the water path, hot rising and cold sinking to take its place.

Make the student supply the cause: heating expands water, its density falls, and denser water around it pushes it up. Until that sentence comes out, convection is only recitation.

Ask the student: why does convection happen in liquids and gases but never in a solid?

Scene 3: Two cans instead of the Sun

A solar demo depends on weather and can ruin a lesson. Use two identical cans, one painted black and one wrapped in foil, lit from the same distance for ten minutes: 12 C against 4 C, a factor of 3. The decisive line is that both sat in the same air, so the difference cannot come from the air.

Then lay out the thermos: the vacuum stops conduction and convection, the silvered wall reflects radiation, and the stopper stops the convection loop. The student points each layer at one route; a wrong point means the model is not yet held.

Ask the student: if both cans warmed equally, would you still blame surface colour?

04 Question types and worked steps

Type Example Steps Answer
Wax ring order Wax at several points along a metal rod Order of melting is the order energy arrives Nearest the source melts first
Convection direction Dye in hot water placed above and below Compare density, not temperature Hot fluid rises, cold fluid sinks
Radiation Black and shiny cans lit for ten minutes Fix the control variables, then read the rise Black 12 C above shiny 4 C
Insulation design Match the three thermos layers to the routes One layer per route Vacuum blocks two, silver blocks radiation
Sanity check (teach this): Four checks: (1) wax must melt from the near end outwards, or the heat source is misplaced; (2) copper beats steel but not by ten times, so 5 against 25 s is credible; (3) dye must rise from the hot side, and a tank that colours evenly means it was poured too fast; (4) the black can must beat the shiny one, 12 against 4 C being a factor of 3, and a near tie means distance or timing differed.

05 Independent practice (3 questions)

Question Answer What to watch
Conduction, four questions Wax order, metal against wood, why a vacuum stops conduction Check for the particle-by-particle sentence
Convection, three questions Where an air conditioner goes, where a tank is heated, dye paths Check for a change of density
Radiation and insulation, three questions Surface colour, 1000 W for 120 s in joules, thermos layers Check the unit is the joule

06 Common mistakes and what to say

Mistake Student writes Say this
Treating heat and temperature as one idea The hotter cup must hold more heat You described temperature; I asked for energy, and the larger cup holds more at the same temperature.
Thinking hot air rises by itself Hot air is light, so it rises Light is the result, not the cause; say the density falls and the surroundings push it up.
Assuming radiation needs air The Sun heats the Earth through the air There is almost no air between them, so that sentence explains nothing.
Saying a thermos just keeps things warm It works because it is a thermos Point to the layer: which one stops conduction, which one stops radiation?

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
Conduction State the melting order and the factor No factor means repeating the rod comparison
Convection Give the reason it needs a fluid Because it is hot is not a reason; ask for density again
Radiation One conclusion from the two-can result Saying black absorbs faster misses the point about no medium

09 Tutor FAQ

Why does metal feel colder than wood

Metal conducts quickly and carries heat away from the skin, so it feels cold even at room temperature.

Why does a vacuum not stop radiation

Conduction and convection need particles, and a vacuum has none; radiation is an electromagnetic wave and crosses it.

Why are air conditioners mounted high

Cold air is denser and sinks, so a high unit circulates the whole room instead of chilling the floor.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →