S2 Physics | Electric Circuits Lesson-Prep Guide (for tutors) | Current, Voltage, Resistance and Ohm Law
- 2026-11-20
Students treat current as something a bulb consumes, so they write a smaller current after the lamp, and they add resistances in parallel. This lesson narrows electricity to three measurable things: charge per second, energy per coulomb, and how much the path obstructs.
01 Prerequisites (3-minute check)
If any of these fails, fix it before the lesson starts.
| Skill | Quick check | Pass mark |
|---|---|---|
| Static charge | Why does a rubbed ruler pick up paper scraps? | It carries static charge and attracts neutral scraps |
| Energy | What does electrical energy become in a lamp? | Light and heat, with no energy lost |
| Units | How many coulombs pass a point each second at one ampere? | One coulomb per second |
02 Lesson flow (60 minutes)
| Time | Stage | Tutor does | Student does |
|---|---|---|---|
| 0-6 min | Diagnose | Ask “does the current get smaller after it passes through the lamp?” and collect answers | Write your own answer and compare at the end |
| 6-16 min | Current is flow | Use 12 coulombs in 4 seconds to get 3 amperes | Work out 45 coulombs in 90 seconds yourself |
| 16-26 min | Voltage pushes | Connect 6 volts across 3 ohms to get 2 amperes | Reverse it: voltage when 0.5 amperes flows through 12 ohms |
| 26-38 min | Series | Draw 4 ohms and 6 ohms in series on 12 volts: 10 ohms, 1.2 amperes | Compute the two voltages 4.8 and 7.2 yourself |
| 38-50 min | Parallel | Put 6 ohms and 3 ohms in parallel: 2 ohms equivalent, 6 amperes total | Write each branch current and say why the total is largest |
| 50-60 min | Lamps are not ohmic | Use 3 volts at 0.2 amperes and 6 volts at 0.3 amperes to get 15 and 20 ohms | Say aloud why resistance rises as the filament heats |
03 Teaching script (read it out)
Scene 1: Current is charge per second, not electricity being used up
The deepest intuition is that a lamp drinks current. Break it with a conservation picture: 12 coulombs pass any cross-section of the lamp in 4 seconds, so the current is 3 amperes. Both sides of the lamp see the same 3 amperes every second; what changes is the energy each coulomb carries.
Require students to say what the unit means every time: one ampere is one coulomb per second. Then 45 coulombs in 90 seconds gives 0.5 amperes so the numbers land. Every later calculation rests on I = Q / t.
Current is how many coulombs pass each second, the same before and after the lamp
Scene 2: Voltage is energy per coulomb, not a bigger push
State voltage as energy released per unit charge: 12 volts means each coulomb hands over 12 joules. In series the two resistors share those 12 volts: 4 ohms takes 4.8 volts and 6 ohms takes 7.2 volts, which adds back to 12.
Teaching move: students label “same current” on the diagram first, then the voltage split. Reverse the order and they will halve the current instead. Parallel is the mirror image: same voltage, split current, 2 amperes through 6 ohms and 4 amperes through 3 ohms, 6 amperes total.
Series: same current, shared voltage. Parallel: same voltage, shared current
Scene 3: Ohm law has a boundary: lamps step outside it
V = IR holds for a fixed resistance. A tungsten filament heats up, so its resistance grows: 3 volts at 0.2 amperes gives 15 ohms, while 6 volts at 0.3 amperes gives 20 ohms, a rise of 33.3 per cent. Its V-I graph is therefore a curve, not a straight line.
Make students state the chain: more current, higher temperature, larger resistance. That sentence is the foundation for senior practical work, and teaching it at S2 removes a re-teach later.
A hotter filament has more resistance, so the V-I graph bends
04 Question types and worked steps
| Type | Example | Steps | Answer |
|---|---|---|---|
| Current | 12 coulombs pass a lamp in 4 seconds: find the current | I = Q / t and always state amperes | 3 amperes |
| Ohm law | 6 volts across 3 ohms: find the current | Write the formula before substituting | 2 amperes |
| Series | 4 ohms and 6 ohms in series on 12 volts: currents and voltages | Add resistances, find current, then multiply each | 10 ohms, 1.2 amperes, 4.8 and 7.2 volts |
| Parallel | 6 ohms and 3 ohms in parallel on 12 volts: total current | Find each branch current then add | 2 plus 4 equals 6 amperes, 2 ohms equivalent |
05 Independent practice (3 questions)
| Question | Answer | What to watch |
|---|---|---|
| Current | 90 coulombs pass a wire in 3 minutes: find the current | Check they convert 3 minutes to 180 seconds first |
| Series split | 3 ohms and 7 ohms in series on 20 volts: find each voltage | Check they get 10 ohms, 2 amperes, then multiply |
| Parallel equivalent | Two 4 ohm resistors in parallel: equivalent resistance | Check they answer 2 ohms rather than 8 ohms |
06 Common mistakes and what to say
| Mistake | Student writes | Say this |
|---|---|---|
| Current consumed | Writing that current falls from 3 to 1 amperes after the lamp | The same charge passes each second; only the energy changes |
| No voltage split | Giving 12 volts to every part of a series circuit | Series parts share the supply voltage and add back to it |
| Parallel resistances added | Adding two 4 ohm resistors to get 8 ohms | A parallel path lowers resistance below any single branch |
| Lamp as fixed resistor | Using 15 ohms to find the current at 6 volts | The hot filament is 20 ohms, so use the right value |
07 Homework (paper, section and question numbers)
- Physics chapter index — All chapters in this subject
- Lesson-prep master index — Matching chapters in other subjects
- Redo this chapter — Re-read with the script open
08 Exit check (last 5 minutes)
| Question | Answer | Decision |
|---|---|---|
| Current | Coulombs per second, unit amperes | Calling it an amount of electricity means re-teach |
| Series and parallel | Series shares voltage, parallel shares current | Swapping them means redraw the circuits |
| Ohm law limit | Lamp resistance rises with temperature | A fixed value means rerun the practical |
09 Tutor FAQ
Should I teach drift velocity?
Not at S2. Charge flow is enough; drift velocity belongs to senior elective work.
Must students memorise the reciprocal formula?
Introduce 1/R = 1/R1 + 1/R2, but for two equal resistors “half of one” builds confidence faster.
Should they plot the lamp curve?
Yes, with two points and one sentence of explanation; the point is that a bend means changing resistance.
Find a tutor — freeTutor Registration →
A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.



