/en-tutor-prep-s3-physics-magnetic-effect-of-current-applications/
/en-tutor-prep-s3-physics-magnetic-effect-of-current-applications/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Secondary Physics (DSE) | Applications of the Magnetic Effect of a Current: Tutor Prep Guide | Ampere-turns before pulling force

Secondary Physics (DSE) | Applications of the Magnetic Effect of a Current: Tutor Prep Guide | Ampere-turns before pulling force

  • 2026-11-22

Students can recite that a current makes a magnetic field, but ask what happens when you add turns and eight in ten promise a stronger magnet without thinking about the resistance.

Objectives — By the end the student can: state that a current-carrying coil has a magnetic field and use the right-hand grip rule to find the poles; use 6 V across 12 ohms to get 0.5 A and explain that strength depends on ampere-turns and the core; calculate the field of a 500 turn, 25 cm air-core solenoid as 1.26 mT, rising to 2.51 mT when the current doubles, and explain why doubling the turns at the same voltage leaves the field unchanged; and describe what the relay, the bell and the motor each use the electromagnet for.

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Ohm’s law 6 V across 12 ohms gives what current? 0.5 A
Magnetic poles Do like poles attract or repel? They repel
Units How many milliamperes are in 1 A? 1,000 mA

02 Lesson flow (60 minutes)

Time Stage Tutor does Student does
0-6 min Prior check Ohm’s law, magnetic poles, current units Two of three correct before moving on
6-16 min A current makes a field Field shapes for a straight wire, a loop and a solenoid Student marks the north pole of a solenoid
16-26 min Current and ampere-turns 6 V over 12 ohms is 0.5 A, 500 turns give 250 ampere-turns Student works out the 1,000 turn case
26-36 min Field strength B equals mu nought n I, giving 1.26 mT and 2.51 mT at double current Student explains why doubling the current doubles the field
36-44 min The core An iron core is magnetised and the field grows sharply Student says the core is not decoration
44-54 min Three applications Relay, electric bell and motor Student explains why a bell keeps breaking its own circuit
54-60 min Exit check Ask whether more turns always means stronger Only if the current holds

03 Teaching script (read it out)

Scene 1: Draw the fields before talking strength

Draw three cases on the board in order: concentric circles around a straight wire, an axial field through a loop, and a solenoid behaving like a bar magnet. Only then give the right-hand grip rule: fingers along the current, thumb points to the north pole. Students must make the gesture themselves, because the most common exam item asks where the north pole goes after the battery is reversed.

Then split strength into two measurable quantities. The first is current: 6 V across a 12 ohm coil gives 0.5 A. The second is turns, and the product is the ampere-turns, the magnetomotive force, here 250.

The field inside a solenoid is B equals mu nought n I, where n is turns per metre. 500 turns over 25 cm gives 2,000 per metre, and substituting gives 1.26 mT. That is small, which is exactly why real electromagnets need an iron core.

Student must say: how are ampere-turns calculated?

Scene 2: More turns is not always stronger

This is the heart of the lesson and the commonest error. With a fixed 6 V supply, going from 500 to 1,000 turns doubles the length of wire and therefore the resistance from 12 to 24 ohms, so the current falls to 0.25 A. The ampere-turns remain 250, identical to before, so the field is identical too at 1.26 mT.

State the condition explicitly: adding turns doubles the field only when the current is held constant, which is what a constant-current supply does. Textbooks say more turns means stronger without mentioning that assumption, and that omission is why the experiment surprises students.

Then the contrast case: current from 0.5 A to 1 A with the same turns takes the field from 1.26 mT to 2.51 mT, exactly double, because B is proportional to I.

Student must say: at the same voltage, does doubling the turns double the field, and why not?

Scene 3: Relay, bell and motor

A relay uses a small current in a coil to switch a large current elsewhere: the coil pulls the armature, the contacts close, and the heavy circuit starts. Its value is isolation and switching, not force. When the coil current stops a spring returns the armature, and students must say this out loud or they will assume the relay latches itself.

An electric bell uses a self-interrupting contact: the current pulls the hammer to strike the gong, and the same motion opens the contact so the current dies, the field collapses, the spring pulls the hammer back, the contact closes, and the cycle repeats many times a second. That is why the ring is continuous. A student who can only say current makes it ring has not understood the lesson.

A motor places a coil in a magnetic field; the two sides carry current in opposite directions, so the forces are opposite and produce a torque. Work one number here: with a field of 0.2 tesla, a current of 3 A and 5 cm of conductor in the field, the force is 0.03 N. Small, which is why real motors use hundreds of turns.

Student must say: why does the current in a bell switch itself off?

04 Question types and worked steps

Type Example Steps Answer
Find the current V equals 6 V and R equals 12 ohms I equals V over R 0.5 A
Find the ampere-turns N equals 500 and I equals 0.5 ampere-turns equal N times I 250 ampere-turns
Find the field n equals 2,000 and I equals 0.5 B equals mu nought n I 1.26 mT
Find the force B equals 0.2, I equals 3, length 0.05 m F equals B I L 0.03 N
Sanity check (teach this): Three sanity checks: an air-core solenoid produces milliteslas, so a few teslas means mu nought was dropped or centimetres used as metres; B is proportional to the current, so doubling the current must double the field; and ampere-turns come out in the tens or hundreds, so 0.25 means milliamperes were used as amperes.

05 Independent practice (3 questions)

Question Answer What to watch
Find the current 12 V across 24 ohms 0.5 A
Find the field Same coil at n equals 4,000 and I equals 0.25 A 1.26 mT
Decide More turns at the same voltage: what happens to the field? Nothing, because the current falls as the resistance rises

06 Common mistakes and what to say

Mistake Student writes Say this
Assuming more turns always means stronger Answering that doubling the turns doubles the field Ask whether the current changed. At fixed 6 V the resistance doubles and the current halves, so the ampere-turns stay at 250.
Treating the core as a bracket Answering that the iron core just holds the coil The core is magnetised by the coil, its domains line up, and the field grows sharply. Every practical electromagnet has a soft iron core.
Thinking a reversed battery changes nothing Answering that reversing the cell only stops it working The current reverses, so the field reverses and the poles swap. The strength is unchanged but the wrong end may no longer attract.
Believing a relay latches itself Answering that the relay stays on after the current stops With no current there is no field and the spring returns the armature, opening the contacts. Holding requires a mechanical latch or a self-holding circuit.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
Source of magnetism A current-carrying coil, with poles from the grip rule A wrong gesture means repeating it
What sets strength Ampere-turns and the core Turns alone means reworking the 1,000 turn case
Applications Relay isolates, bell self-interrupts, motor makes torque No bell cycle means repeating the idea

09 Tutor FAQ

Why is an electromagnet more useful than a permanent magnet

Its field disappears almost at once when the current stops, its strength can be adjusted and its polarity reversed, none of which a permanent magnet can do, which is why cranes and relays use coils.

Why does an electromagnet need a soft iron core

Soft iron magnetises easily and loses its magnetism easily, so the field is much stronger while the current flows and the residual magnetism is small afterwards. Steel would stay magnetised and refuse to release the load.

What is the difference between doubling the current and doubling the turns

Doubling the current doubles the field directly; doubling the turns while the resistance also doubles halves the current, and the two effects cancel so the field is unchanged. To really double the field, raise the current or use thicker wire.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →