/en-tutor-prep-s3-physics-magnetism-electromagnetism-practice-4/
/en-tutor-prep-s3-physics-magnetism-electromagnetism-practice-4/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Paper 4: common mistakes in magnetism

Paper 4: common mistakes in magnetism

  • 2026-11-21

Paper 4: common mistakes in magnetism

Chapter practice with ten items, answers and a one-line note for each, about 25 minutes.

Paper 4 Ten items on this chapter with answers for immediate marking.

01 Paper details (check answers afterwards)

Item Detail
Questions 10
Suggested time 25
Difficulty mix Foundation 4 · Intermediate 2 · Challenge 2 · Error redo 2
Chapter Chapter: Magnetism and electromagnetism
Level Retry

02 Questions (10 items)

  1. FoundationA student multiplies B I L by cos 60 for a wire perpendicular to a 0.4 T field. What is the correct force for 2 A and 0.5 m?
  2. FoundationA student works out 440 V for a 220 V transformer with 200 primary and 100 secondary turns. What is the correct output?
  3. FoundationA student says a transformer can step down direct current. Is that right?
  4. FoundationWhy raise the transmission voltage to improve efficiency?
  5. IntermediateA student says two field lines cross at a point. What is the correct statement?
  6. IntermediateA student writes T as the unit of current. What is the correct unit?
  7. ChallengeA student claims an electromagnet keeps its magnetism after switching off. What is correct?
  8. ChallengeTwo parallel wires carry current in opposite directions. A student says they attract. What is correct?
  9. Error redoA student obtains an efficiency of 1.2 for a transformer. What went wrong?
  10. Error redoA student uses 20 m instead of 20 cm. What is the correct force for 0.5 T, 2 A and 20 cm?

03 Answers and one-line notes

# Answer One-line note
1 0.4 N The angle is 90 degrees, so the factor is 1 and no extra multiplier is needed.
2 110 V Divide secondary turns by primary: 220 x 100 / 200 = 110 V.
3 No A transformer needs a changing flux; steady DC induces no voltage in the secondary.
4 Higher voltage means lower current and less I^2 R loss For the same power P = V I, raising V lowers I.
5 Field lines never cross The field has only one direction at each point, so crossing is impossible.
6 ampere (A) T measures flux density, not current; current is measured in amperes.
7 A soft iron core loses its magnetism almost immediately Soft iron demagnetises easily, which is why an electromagnet can be switched on and off.
8 They repel each other Opposite currents give opposite fields, so the wires repel.
9 Input and output power were swapped Efficiency is output over input, so it must be below 1.
10 0.2 N 20 cm is 0.2 m, so 0.5 x 2 x 0.2 = 0.2 N.

04 What to do after marking

  • After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
  • Repeat the same item two days later; move to the next paper only when both attempts are correct.
  • Parents only need the answer and note columns; there is no need to explain every item.

Mark your answers at once; check that the wire is perpendicular to the field, and sort out the turns ratio before using the transformer formula.Tutor Registration →

Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →