S3 Science practice: rate of chemical reaction (Paper 3, 10 challenge items)
- 2026-11-17
← Back to the Secondary Science chapter index
S3 Science practice: rate of chemical reaction (Paper 3, 10 challenge items)
This paper is calculation heavy: finding a total from rate and time, rate factors from time ratios, percentage yield and collision frequency, for students aiming high.
Rate calculations, 10 challenge items Ten items on total amount from rate and time, rate factors from time ratios, percentage yield and collision frequency, with answers and one-line notes.
01 Paper details (check answers afterwards)
| Item | Detail |
|---|---|
| Questions | 10 |
| Suggested time | 25 |
| Difficulty mix | Foundation 3 · Intermediate 3 · Challenge 3 · Error redo 1 |
| Chapter | Chapter: S3 Science: rate of chemical reaction |
| Level | Challenge |
02 Questions (10 items)
- Foundation3 g of magnesium reacts completely in 60 seconds. What is the average rate in g/s?
- FoundationA reaction runs at 0.4 g/s for 90 seconds. How much reactant is used up?
- Foundation150 cm3 of gas is collected in 2.5 minutes. What is the average rate in cm3/min?
- IntermediateThe time for a reaction falls from 24 s to 8 s. By what factor does the rate change?
- IntermediateIn the same time, the mass loss falls from 12 g to 4 g. What fraction of the original rate is that?
- IntermediateTemperature rises from 20 to 40 degrees. If the rate doubles for each 10 degree rise, how many times faster is it?
- ChallengeA reaction should give 50 cm3 of gas but only 40 cm3 is collected. What is the percentage yield?
- ChallengeA reaction normally takes 100 s. If the rate is doubled, how long does it take?
- Challenge100 cm3 of 1 M hydrochloric acid and 100 cm3 of 0.5 M acid react with the same amount of magnesium. Which has the higher collision frequency?
- Error redoA student thinks adding a catalyst increases the total amount of product. Is that right?
03 Answers and one-line notes
| # | Answer | One-line note |
|---|---|---|
| 1 | 0.05 g/s. | 3 divided by 60 gives 0.05, so keep three decimal places. |
| 2 | 36.0 g. | Rate times time: 0.4 multiplied by 90 gives 36.0. |
| 3 | 60.0 cm3/min. | 150 divided by 2.5 gives 60.0, with time kept in minutes. |
| 4 | Three times. | 24 divided by 8 gives 3, so the rate is three times larger. |
| 5 | One third. | 4 divided by 12 gives one third, so the rate has dropped to a third. |
| 6 | About 4 times. | A 20 degree rise is two steps, each doubling the rate: 2 times 2 gives 4. |
| 7 | 80 per cent. | 40 divided by 50 then multiplied by 100 gives 80. |
| 8 | 50.0 seconds. | Rate is inversely proportional to time, so doubling the rate halves the time: 100 divided by 2 gives 50. |
| 9 | The 1 M acid. | The higher concentration means more acid particles in the same volume, so more collisions. |
| 10 | No. A catalyst only speeds up the reaction; the total amounts are unchanged. | The amount of reactant sets the maximum amount of product, regardless of the catalyst. |
04 What to do after marking
- After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
- Repeat the same item two days later; move to the next paper only when both attempts are correct.
- Parents only need the answer and note columns; there is no need to explain every item.
Download the full ten-item paper as a PDF, answers and notes included.Tutor Registration →
Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.



