/en-tutor-prep-s3-science-rate-of-reaction-factors/
/en-tutor-prep-s3-science-rate-of-reaction-factors/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

Junior Science: Rate of Reaction Tutor Prep Guide — Measuring Rate, Four Factors and Collision Theory

Junior Science: Rate of Reaction Tutor Prep Guide — Measuring Rate, Four Factors and Collision Theory

  • 2026-11-17

This lesson turns fast and slow into numbers, then makes pupils explain every factor with collisions.

Objectives — [‘Calculate average rate as change divided by time, with the correct unit.’, ‘Explain how concentration, surface area, temperature and a catalyst change rate, giving one observable piece of evidence for each.’, ‘Use the three conditions of collision theory (collision, enough energy, correct orientation) and state that a catalyst does not change the amount of product.’]

01 Prerequisites (3-minute check)

If any of these fails, fix it before the lesson starts.

Skill Quick check Pass mark
Unit conversion Convert 2 minutes into seconds 120 seconds
Division What is 60 divided by 120 0.5
Reading an instrument Read a syringe moving from 20 to 80 cubic centimetres 60 cubic centimetres

02 Lesson flow (60 minutes)

Time Stage Tutor does Student does
0–5 min Starter and quick check Two tubes, one powder one lump, acid added at the same time Watch which finishes fizzing first and predict why
5–20 min Act 1: measuring rate Write the formula, work one syringe calculation Follow the calculation and check units
20–35 min Act 2: four factors Change one variable at a time for each factor Fill a four-row table: what changed, what was seen, why
35–48 min Act 3: collision theory Draw three collisions, circle the slow and badly aimed ones Re-explain one factor using the three conditions
48–56 min Independent practice Three minutes per question, mark units and reasoning Finish three questions with units
56–60 min Exit check Collect answers, mark at once, note what to reteach Answer and self-check

03 Teaching script (read it out)

Scene 1: Measuring rate

Give three measurable signals: gas volume on a syringe, mass loss on a balance, and time for a colour change or precipitate. Each becomes a number, and a number is what makes it a rate.
One formula only: average rate equals change divided by time. Model it: 60 cubic centimetres of hydrogen collected in 120 seconds gives 0.50 cubic centimetres per second.
Then separate average from instantaneous: 36 cubic centimetres in the first 30 seconds is 1.2 per second, 12 cubic centimetres in the next 30 seconds is 0.4, and the whole 48 cubic centimetres in 60 seconds averages 0.8. An average always sits between the fastest and slowest stretch.
Pupils do: use balance data, 2.4 grams lost in 80 seconds, to get 0.03 grams per second.
Pupils say: why the rate falls in the later part of a reaction.

Pupils repeat: average rate equals change divided by time, and the unit must be written.

Scene 2: Four factors

Group the factors: concentration and surface area change how often particles collide, temperature changes both frequency and energy, and a catalyst opens another route.
Concentration: a stronger acid has more particles per unit volume, so collisions are more frequent. Surface area: the same 2.0 grams of marble chips as powder finish in 40 seconds, 0.05 grams per second, while lumps take 100 seconds, 0.02 grams per second, a factor of 2.5.
Temperature: roughly double for every 10 degrees, so 20 to 50 degrees is three intervals and about eight times faster. A catalyst lowers the energy needed, speeds up the reaction and does not change the final amount of product.
Common misconception: pupils treat a catalyst as a reactant and write that adding it produces more oxygen. Point out that a catalyst is not consumed and does not appear in the balanced equation, so the product amount is set by the reactants.
Pupils do: complete a four-row table with only what changed, what was seen and why, no vague “it is faster”.
Pupils say: why powder is faster than lumps while the total gas collected is the same.

Pupils repeat: concentration and surface area change collision frequency, temperature changes frequency and energy, a catalyst changes the energy needed.

Scene 3: Collision theory

A reaction needs particles to collide, with enough energy, and in a suitable orientation. Three sentences explain all four factors.
Map them one by one: more concentration means more collisions per second; more surface area means more particles exposed; higher temperature raises average kinetic energy, so both the collision frequency and the share of collisions with enough energy rise, which is why temperature matters more than concentration.
A catalyst lowers the energy needed, so more collisions become successful; it speeds up the forward and reverse reactions equally, so it does not shift the position of equilibrium or change the total product.
Pupils do: rewrite one factor from Act 2 using the three conditions, with the words collision and energy in every sentence.
Pupils say: why “particles move faster” alone does not explain the increase in rate.

Pupils repeat: collisions must be frequent, energetic enough and well aimed; a catalyst lowers the energy needed.

04 Question types and worked steps

Type Example Steps Answer
Rate calculation 60 cubic centimetres collected in 120 seconds Change divided by time, unit per second 0.50 cubic centimetres per second
Comparing rates Powder and lumps of the same mass Compute each rate, then divide Powder 0.05, lumps 0.02, so 2.5 times faster
Temperature From 20 to 50 degrees Count 10-degree intervals, double each Three intervals, about eight times
Explanation Why heating speeds a reaction up Collisions: more frequent and more energetic More collisions, and more of them succeed
Sanity check (teach this): Sanity check: a rate without a unit loses marks, so always write per second or per minute. Time must use one unit, since mixing seconds and minutes is a factor of sixty. The average rate must lie between the fastest and slowest stretch; an average above every stretch means the total was misread. Doubling every 10 degrees is an estimate, so write about rather than certainly. A catalyst does not change the final amount of product, and saying it does is a conceptual error. Powder and lumps must give the same total gas, otherwise gas escaped collection.

05 Independent practice (3 questions)

Question Answer What to watch
60 cubic centimetres in 120 seconds, find the average rate 0.50 cubic centimetres per second Whether the unit is written
2.0 grams of marble chips: powder in 40 seconds, lumps in 100 seconds, find both rates Powder 0.05 grams per second, lumps 0.02 grams per second Whether each rate is computed before comparing
How much faster from 20 to 50 degrees About eight times Whether three 10-degree intervals are counted

06 Common mistakes and what to say

Mistake Student writes Say this
Rate without a unit The rate is 0.5 Rate is change divided by time, so what is your unit?
Mixed time units Using 2 minutes with 60 seconds in one calculation Both numbers must use the same unit before dividing.
Catalyst as a reactant Adding a catalyst gives more oxygen Does the catalyst appear in the equation?
Temperature stated as exact Every 10 degrees is exactly twice as fast That is an estimate; the question asks for about how many times.

07 Homework (paper, section and question numbers)

08 Exit check (last 5 minutes)

Question Answer Decision
Formula Average rate equals change divided by time Multiplying means reteaching Act 1
Temperature Three intervals, about eight times Answering twice means miscounting intervals
Catalyst Speeds up the reaction without changing the product amount Saying more product means reteaching Act 3

09 Tutor FAQ

Must pupils memorise the formula

They should write change divided by time themselves and find both quantities in the question.

How deep should collision theory go

At junior level three conditions are enough: collision, enough energy, suitable orientation.

What if there is no equipment

A balance for mass loss or a syringe for gas volume both give numbers you can use.

Find a tutor — freeTutor Registration →

A TutorZone lesson-prep guide. Written by the TutorZone team; questions and lesson flow are original and are not taken from any school or publisher material.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →