/en-tutor-prep-s3-science-rate-of-reaction-factors-practice-4/
/en-tutor-prep-s3-science-rate-of-reaction-factors-practice-4/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

S3 Science practice: rate of chemical reaction (Paper 4, 10 retry items)

S3 Science practice: rate of chemical reaction (Paper 4, 10 retry items)

  • 2026-11-17

S3 Science practice: rate of chemical reaction (Paper 4, 10 retry items)

This paper targets the most common misconceptions: catalysts do not raise the yield, a flat curve is not a stop, and a longer time means a slower rate.

Common mistakes retry, 10 items Ten items correcting common errors about catalysts, surface area, graph reading, unit conversion and the inverse link between time and rate, with answers and one-line notes.

01 Paper details (check answers afterwards)

Item Detail
Questions 10
Suggested time 25
Difficulty mix Foundation 3 · Intermediate 3 · Challenge 3 · Error redo 1
Chapter Chapter: S3 Science: rate of chemical reaction
Level Retry

02 Questions (10 items)

  1. FoundationIf the amount of catalyst is doubled, does the total amount of product double?
  2. FoundationWhy does a powder react faster than lumps?
  3. FoundationHeating speeds up a reaction mainly because of what change in the particles?
  4. IntermediateWhen a higher concentration speeds up a reaction, what does concentration mean?
  5. IntermediateIf a rate curve becomes almost flat, does that mean the reaction has stopped?
  6. IntermediateWhat property must a gas have before it is collected over water?
  7. ChallengeHow is an average rate calculated?
  8. ChallengeA reaction gives off 90 cm3 of gas in 30 seconds. What is the average rate in cm3/s?
  9. ChallengeHow many seconds are in 2 minutes, and which time value is used in a rate calculation?
  10. Error redoA student says a longer reaction time means a faster rate. What is wrong?

03 Answers and one-line notes

# Answer One-line note
1 No. The total product depends on the amount of reactant. The catalyst only changes the time needed to finish.
2 Because the surface area is larger. Impurities or colour are not the key factor here; surface area is.
3 Their average kinetic energy rises, so collisions are more frequent and more energetic. Temperature reflects average kinetic energy, and higher energy makes it easier to overcome the energy barrier.
4 The number of reactant particles per unit volume. A higher concentration means more particles in the same space, so more chances to collide.
5 Not necessarily; it only means the rate has become very small. As the reactant runs out the rate becomes very low and the curve looks flat.
6 It must be only slightly soluble in water. A soluble gas would dissolve during collection and the measured volume would be too low.
7 Total change divided by total time. It describes the whole reaction and cannot represent one instant.
8 3.0 cm3/s. 90 divided by 30 gives 3.0.
9 120 seconds; use 120 seconds. The time unit must match the time unit of the rate, or the number will be wrong.
10 A longer time means a slower rate; the two are inversely related. The same amount of reactant taking longer must have a lower average rate.

04 What to do after marking

  • After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
  • Repeat the same item two days later; move to the next paper only when both attempts are correct.
  • Parents only need the answer and note columns; there is no need to explain every item.

Download the full ten-item paper as a PDF, answers and notes included.Tutor Registration →

Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →