/en-tutor-prep-s6-chemistry-spectrophotometry-chromatography-practice-3/
/en-tutor-prep-s6-chemistry-spectrophotometry-chromatography-practice-3/
General Inquiry: info@TutorZone.com.hk
Office Hours: Monday to Saturday - 9:00 AM to 6:00 PM
WhatsApp Monday to Sunday - 24 hours
Hotline: +852 6828 1809
Instant Support: +852 9061 3106

S6 Chemistry Spectrophotometry and Chromatography Practice 3 (Challenge)

S6 Chemistry Spectrophotometry and Chromatography Practice 3 (Challenge)

  • 2026-11-18

S6 Chemistry Spectrophotometry and Chromatography Practice 3 (Challenge)

Ten items cover transmittance back-calculation, a dilution series, peak area percentages, blank subtraction and readings beyond the linear range.

Calibration curves and quantitative analysis Correct the reading first (blank, dilution factor), then use the calibration line to find the concentration.

01 Paper details (check answers afterwards)

Item Detail
Questions 10
Suggested time 25
Difficulty mix Foundation 4 · Intermediate 2 · Challenge 2 · Error redo 2
Chapter Chapter: S6 Chemistry: spectrophotometry and chromatography
Level Challenge

02 Questions (10 items)

  1. FoundationA solution has absorbance 1.30. Find the transmittance.
  2. FoundationAbsorbance 0.72, concentration 4.0×10^-4 mol dm-3 and cell length 1.5 cm. Find epsilon.
  3. FoundationPortions of 2.0, 4.0, 6.0 and 8.0 cm3 of 2.5×10^-3 mol dm-3 stock are each diluted to 50.0 cm3. With epsilon = 1500 and l = 1.0 cm, give the four absorbances.
  4. FoundationWhich locating agent is used for amino acids in paper chromatography, and why is it needed?
  5. Intermediate8.0 mg of a complex of molar mass 320 g mol-1 is made up to 250 cm3 and reads 0.62 in a 2.0 cm cell. Find epsilon.
  6. IntermediateThree GC peaks have areas 12.0, 36.0 and 12.0 units. Give the percentage of each component.
  7. ChallengeThe blank reads 0.04 and the sample 0.46, with epsilon = 1400 dm3 mol-1 cm-1 and l = 1.0 cm. Find the true concentration.
  8. ChallengeA stock reads 1.85, beyond the linear range. Diluted fivefold it reads 0.37, corresponding to 2.5×10^-4 mol dm-3. Find the stock concentration.
  9. Error redoA student claims that absorbance 2.0 means 20% of the light is transmitted. Where is the error?
  10. Error redoA spot has Rf 0.95 and sits right at the solvent front. How does this affect identification?

03 Answers and one-line notes

# Answer One-line note
1 T = 10^-1.30 = 0.0501, about 5.0%. An absorbance above 1 means less than one tenth of the light passes.
2 epsilon = 0.72 / (4.0×10^-4 x 1.5) = 1200 dm3 mol-1 cm-1. The denominator must multiply both concentration and path length.
3 Concentrations are 1.0×10^-4, 2.0×10^-4, 3.0×10^-4 and 4.0×10^-4; absorbances are 0.15, 0.30, 0.45 and 0.60. From one stock, concentration is proportional to the volume taken.
4 Ninhydrin; the amino acid spots are colourless, so they must be developed before they can be seen. A locating agent reacts with one functional group only, which also improves selectivity.
5 n = 8.0×10^-3 / 320 = 2.5×10^-5; c = 1.0×10^-4; epsilon = 0.62 / (1.0×10^-4 x 2.0) = 3100 dm3 mol-1 cm-1. Get moles from the mass, then concentration, then rearrange for epsilon.
6 Total area is 60.0, so the percentages are 20.0%, 60.0% and 20.0%. Peak area is proportional to amount; sum first, then take each proportion.
7 A = 0.46 – 0.04 = 0.42; c = 0.42 / 1400 = 3.0×10^-4 mol dm-3. Subtract the blank from the sample reading or the concentration comes out too high.
8 c = 2.5×10^-4 x 5 = 1.25×10^-3 mol dm-3. Multiply back by the dilution factor, and make sure the diluted reading falls inside the calibration range.
9 A = 2.0 gives T = 10^-2 = 1.0%, so only one hundredth of the light passes. Each increase of 1 in absorbance divides transmittance by ten.
10 It overlaps the front and Rf cannot be measured accurately; use a less polar eluent so the spot moves towards the middle. An Rf between 0.3 and 0.7 is ideal; values too low or too high are hard to resolve.

04 What to do after marking

  • After marking, redo only the wrong items and write down which step went wrong (formula, unit, or misread number).
  • Repeat the same item two days later; move to the next paper only when both attempts are correct.
  • Parents only need the answer and note columns; there is no need to explain every item.

Download the full ten-item paper as a PDF, answers and notes included.Tutor Registration →

Questions and answers are written originally by the TutorZone team and are not taken from any school, publisher or examination authority paper. Every value is checked by computer.

Join as a tutor or coach — academic, music, sports, arts, STEM. Free to register. See how it works →